Dyno in 4th or 5th? 6MT
 

What's the standard that everyone uses? i know 5th is 1:1 but i'm pretty sure that a 5k rpm pull with 160whp would take about 6hrs... so does everyone dyno in 4th or 5th?

5th gear. Looking back at the videos on my phone, each run took about 15-20 seconds to get from cruising on the dyno in 5th to redline.

4th

4th is 1:1 if im not mistaken

5th is 1:1 on our close ratio manual 6-speed.
The automatic's 1:1 is fourth gear.

^^My bad!

it's all good. There has been a bit of confusion between the two. I had originally linked a thread on the forum in my response, but in the first post the OP had swapped the AT and MT labels. It was called out by others in the thread, but still makes a confusing first post.