Home-made single exit exhaust cover
 

I made this in my garage in about 20 minutes, and under $10. I got a thin cutting board thing from target for like $1, and some 3m heavy duty double sided tape. Then I took a blank piece of paper and put it over the empty exhaust hole. With a crayon I colored over the edges of the lip, then put the cutting board over the paper and cut along the lines the crayon made. Then just put thhe 3m tape alo the inside off the cut plastic you just made, and then stick it on over the hole.

http://i.imgur.com/JU6IxVZ.jpg

looks pretty clean for a diy job and cost. i wonder how it would hold up over time after driving on freeways for awhile since it's just 3m tape.

This pic is after about 2 weeks

Still on there tight

I might just have to try that, thanks!