DIY request: Gauge install and wire routing
 

I hate posting new posts when one already exists but I searched this forum for a while yesterday and couldn't find anything. I'm deployed and when I get back I'm going FI, but I'm trying to do my research now so I can hook up the gauges, clutch and anything else I can do myself before I get back so I will have an easier time with the install. Where have all of you guys been running your wires for your gauges? I'm looking to do a super clean install, the gauges I'm going to be using are an AEM Failsafe, Innovate Motorsports Oil temp/Pressure and Innovate Batt Volt/Water Temp. I already bought an ATI Vent Gauge Pod, DCW Gauge Pod, and a steering column gauge pod, so the routing should be fairly easy I just wanted to see how you guys did it before I screw it up by myself.

Look at Autometer's BRZ-Scion FR-S installation for some tips. Also see Lunatic's nice gauge install in the DIY section. Thank you for your service and hope you're having a good 4th of July!

Thank you so much, Autometer's site was exactly what I was looking for.

Nothing beats going down the road with a good set of gauges staring back at you! Plus you learn how to work upside down with your head jammed under a dashboard--and then your phone rings.