p0198 code oil temp sensor malfunction circuit high
 

Finised my jdl turbo install started her up then threw that code...bad sensor? installed tee wrong? Any ideas

Did you wrap it in Teflon tape. You may have used too much and now the sensor isn't grounded through the block any more

Sent from my SPH-L710 using Tapatalk

I used thread sealer

Did you leave some of the threads , on both the adapter and the sensor, uncoated?

Sent from my SPH-L710 using Tapatalk

Ill play with it tonite thanks man

The obvious question would be did you hook the spade connector back on to the sending unit.

Also a good one haha.

Sent from my SPH-L710 using Tapatalk

Yes its hooked up

Ever get this cleared up?

Sent from my SPH-L710 using Tapatalk

I should find out tonite..i forgot to put the fitting that goes to the tee and block because i didnt see the fitting hiding in the box..i put the tee directly in the block i hope that was caused the code

ah good luck man, just started mine up for the first time last night