Help camber bolts installation
 

Is this the correct orientation? Do I need that plate showed on the second picture? It seems it does not fit well to my struts. Thanks

Sent from my SGH-T999 using Tapatalk

The tab should point in the direction you want the wheel to go. An example would be towards the outside for positive camber and towards inside for negative adjustment, you want it at 3 or 9 o'clock.

As for that spacer washer piece, I have never seen one of those on a front camber bolt kit, could be a lockout for an oem camber bolt, I wouldnt worry about it. GL

that plate is not for this car. that tab should be facing the engine not vertical. if neg camber is what you are after. If there is a arrow on the bolt head by the tab that arrow needs to face the tire if you want max neg camber.

http://stores.mengmotorsports.com/images/81250dwg.jpg

Thanks alot

Sent from my SGH-T999 using Tapatalk

But the adjuster was blocked by the strut assembly. See picture 1. Is that ok to set up that way? I want max neg camber.

Sent from my SGH-T999 using Tapatalk

I only can max with this. Is that ok? Thanks. Im looking for max neg camber

Sent from my SGH-T999 using Tapatalk

That will do for now, but if you really wanted the full adjustment it's best to have it directly horizontal, if ya can cut the tab or trim the washer and remember where it was could be a solution for that situation


Sent from my iPhone using Tapatalk

If it gets you the desired camber you were after, just leave it as it is. If not, get some camber tops instead.

This post made me realize there is no DIY for OEM camber bolt install. Someone should post one up

"It puts the bolt in the hole"


Sent from my iPhone using Tapatalk

According to Whiteline, you have it on backwards.

http://www.whiteline.com.au/docs/ins...uides/Z201.pdf

I cant mount on the other side. My slotted hole is too small the camber bolt.

Sent from my SGH-T999 using Tapatalk

HELP!! I CANT GET NEGATIVE CAMBER. Only zero or positive! Any ideas??!! I faced inside my washer.

Sent from my SGH-T999 using Tapatalk

Do I need to lose strut top 3 nuts to adjust negative?

Sent from my SGH-T999 using Tapatalk