Vortech and cusco oil catch help
 

Hey everybody. I'm wanting to put in a oil catch can but unsure of how to route it in terms of plumbing w the vortech. Any help would be great! Thanks !!!

Where does the PCV Hose mount on the Vortech Kit?

Thanks for the reply ! I believe the one vortech had me splice in one is from the top of the intake manifold and goes down to the block.

If you spliced one that goes to the intake manifold from the PCV (Positive Crankcase Ventilation) which would be on the Valve cover(s)...that is where you would mount the catch can between. I would look over the instruction and see if that is the PCV line.

Where did you splice it to?

I know this is no help but I honestly don't remember. It was specific in the instructions and i went to the hose and spliced it there. My car isn't here right now but I'll check once I have it back in a few hours or so

I just messaged you. Image is for PCV. (Must use hoseclamps, PCV is under vacuum leaks can cause tuning issues)


For breather run tube behind AC compressor to inlet of second catch can, then outlet of catch can to inlet of Vortech Airbox.