anyone running 255/40/17s? 1"drop?
 

im lowered on rce springs and wondering how 255s will fit, I have some 17x9+35 I need rubber for and am wondering how much rubber I can fit without rubbing. pic's would be greatly appreciated. thank you

You are good to go on that setup.

http://ft86speedfactory.com/images/frs_enkei_rpf1-3.jpg

One more...

http://ft86speedfactory.com/images/frs_enkei_rpf1-4.jpg

Didja have to roll fenders?

ft-86 looks awesome ill go ahead and get em then thank you

I'm on 255s and a lot lower than that on coils. 17x9 et40.

http://i67.photobucket.com/albums/h3...ps10585c00.jpg

255 fit the x9 perfectly but I think wheel +35 will poke a little. Is it right?

Regarding rear fitment:

From my experience w/ 17x9 +35s & 255s--I had some rubbing in rear on one side. My rear camber was wonky from the factory (-1.3 & -2) & it rubbed on the -1.3 side. I've since corrected that w/ adjustable rear LC arms.

My conclusion is that if you have -1.7 or more on both sides in rear, you should be fine.

I'm running 255/35/17 on 17x9.5 +38 RPF1. I get rubbing on both rears and I'm about the same height in the rear as the red one posted above. I can't hear it when it's happening but you can see the evidence on the tire. I think I'm about -1.8 in the rear. I've got a set of RacerX rear LCA on the way to fix this.

Will 255s on 17x9 +35 fit with RCE Yellows and 3 degrees camber? Or will the tire rub the spring perch? Assume 1.5 degrees with the camber bolt and 1.5 with the top hat.