How to gut the interior?
 

I want to start my sound deadening project for the entire floor,side panels, and doors of the FRS. I searched but had no luck finding a tutorial on how to disassemble the whole interior. I'm sure quite a few modders have done this. Are there any guides out there?

This might better be aimed at the DIY request section.

Tried a month back but no luck :iono:
I figured a thread here might catch some attention?

Ah yeah, I think the information you are looking for is out there but it is not in one place. For example, one user might have removed the back paneling by the rear seats in order to get to a ground wire while another user might have removed the door cards to install courtesy lights. You can try downloading the service manuals (not the user manual that comes with the car) to see if there are any tips in there. Otherwise, you're gonna have to write up a DIY for everyone since it seems you're the first!

To take out panels:

1) Literally look/feel for fasteners.
2) Remove fasteners
3) Remove component

To install panels:

1) Replace component
2) Replace fastener

It's literally self explanatory. They're either bolted/screwed into place, or snapped in. Generally the bolts/fasteners are visible or accessible with your tools, but this isn't rocket science.

I just finished my sound deadening. This was helpful.

http://www.ft86club.com/forums/showthread.php?t=35604


Sent from my iPhone using Tapatalk

Thanks for the input guys! Il probably start with the doors and trunk/wheel well next week. As for the rest of the cabin, Il dedicate one weekend to get it all done.

From my experience. The doors, inside the rear quarter panel and then the floor was the most beneficial.

I took some pillows and stuffed them in the opening behind the rear speakers after I put dynamat all over the metal.


Sent from my iPhone using Tapatalk