Part Number for OEM Scion H11 Foglight Harness
 

Anyone happen to know if there is a Part Number for the H11 Foglight Harness in the OEM Scion foglight kit? The harnesses look really well built and would rather just buy those than to look for those female terminal pins and construct my own.

I believe the answer is no because the only part number is for the full kit, not individual parts.

All you do is ground it and run te power wire to the empty connector in te stock sidemarker harness.

Does the OEM Scion fog light kit use H11 bulbs?

I believe the BRZ and GT86 (overseas) both use PSX24W bulbs/plastic housing. I thought the OEM scion fog light upgrade would probably be the same.

I think you gotta get the Subaru Outback Glass Fog Lights for the H11 bulbs (which is the route I went). In this case, Scion wouldn't have any H11 harnesses.

Your partially right. The new fog light kit does carry h11 55 watt bulbs and are glass fog lights.
See last two posts on this page.

http://www.ft86club.com/forums/showt...t=40153&page=2

It's simple if you have the materials. I can't seem to find the pin that fits in the empty connector. Suggestions?

For me the best thing was to buy the same connector from toyota and take out 2 of the pins to use, plus you will have spares in case you break one.

This ^

Do u have the part number u purchased?

I do but not near it currently, I will be sure to post it sometime tomorrow morning.

Part # is SU003-02583

This is the best news ever!

Ordered my FR-S with the OEM fogs and I thought I was gonna have to deal with finding replacements for those hard to find bulbs.

Yes you wont have any worries about light quality, although personally I think the "OEM" kit isnt worth the money since its just a button and could easily be done cheaper.

last question, did you just need to order 1 and reuse the 2 of the 3 pins for each harness? or do I need to order 1 for each side?