CEL, Skid Light, Rough Idle ...
 

I'm here again ... with a problem whit my Scion FRS

I'ts been almost a month since my CEL and the dealer is not able to fix it. They change the ECU, intake gasket was leaking so they change it. Made couple of test and know they told me that a ABS sensor was faulty. I told to check the rough idle but didn't bother too much. Every week i got to the dealer with the car and no improvement. So anyone got some idea ? Tomorow i gonna call toyota canada again to complaint about the poor service of the Tech and i will change dealer.

any cel codes?
i have rough idle at start up.


http://www.youtube.com/watch?v=IqJy0...ature=youtu.be

Any way to pull the codes? You can get 10 dollar bluetooth odbII adapters on ebay (I bought two!). There's a free android app called Torque you can use to read the codes on.

I've read in the past that the CEL + slip light combo points towards a crank sensor. They're a fairly common failure point on these cars from what I've read. There's a TSB or two on it as well.

15 may 2013
#VIN 7032XX

P0171, P117B Sensor short-circuit so they change the Mass Air Flow Sensor

SU003-00425 ... And guess what ... nothing happen.

Since then i don't have the other code.

Wait
I had that code
And it was my spark plugs and DI seals

DI seals as been change in december 2012. check my older thread
http://www.ft86club.com/forums/showthread.php?t=23810

i think i was in the first that this problem occur back in november 2012.

they spend 1 month to fix this issue.

I gonna check the spark plugs tomorow. Did you got some backfire when your DI seals was burn ?

nop just car was shaking like a MOFO but no misfires codes just the codes you are showin now

check my new post for progess
http://www.ft86club.com/forums/showt...62#post1079962