Can't read ECU
 

Hey,

I've been installing a vortech supercharger kit with a new fuel pump, new injectors and ecutek tune.

I installed everything, flashed the ECU with a tune and started it up... it worked!!!

BUT!

It started leaking gas from around the fuel pump so I quickly stopped the car from running.

I took out the fuel pump, fixed the leak and now it's back in but now the car won't start!

When I put the key in to "ON", I don't hear the pump working.

- Because I tested the pump separately, I know it works.
- I also tested the wiring going to the pump separately (the wiring in the fuel canister) and it works.
- I checked the fuses and they seem ok. I replaced one that seemed to have blown.

Now I'm trying to reconnect to the OBD connector to 'reflash' the ECU and I can't even connect to the ECU!!!

--> So... car won't crank, I don't hear the fuel pump working when it's on the "ON" position.

--> Can't access the ECU from ECUtek Dongle anymore! (Related I suppose)

Help?! The car started fine ONCE before when there was a fuel leak.
Thanks

Are you getting any power at all? Relay gone maybe? Definitely seems electrical and the ECU isn't powering up.

disconnect the battery for 15 minutes and connect it baack again

I'm getting power, everything lights up when I'm on "ON" but nothing happens when I turn the key.