Stock exhaust bolt/nut sizes?
 

Hey I am swapping my downpipe on my aftermarket exhaust out back to my stock but seemed to misplace my old bolts and nuts. Does anyone know the stock bolt/nut sizes?

Also as long as the bolts and nuts go flush it shouldnt matter if the hole on the midpipe is slightly larger as long as the bolt/nut is torqued to the correct amount correct?

Thanks

Subscribed, because yesterday I went to check the nuts on my header after the 100 miles and I'm missing a header nut.

Wild random guess M6 1.25

Well I'm going to the store and buying a bunch of nuts and bolts. Will report back when I figure it out.

If you can wait, I could send you mine for the overpipe. Just did it a few days ago, and think I reused the old instead of the replacements.

Not sure if it was 100% tight but I used a M8 - 1.25 - 35mm

Can you confirm that's correct? :o

Sorry it was too long ago to make sure =X

Anyone know the answer?