Weld Drag Rims
 

Anyone know or not if its possible to fit 15x10's on the back? and if so what backspacing

i'd say maybe about 8 or so inches maybe?

i had a 18x11J +25 on the rear and the barrel was hitting the wheel well at -10 degrees of camber, and had to dial it down to -9.5

On the wheel i have 7" of backspacing, but with all that negative camber i think we can fit maybe an inch or two more of backspacing with a very low negative camber setup. Hope this helps

outside off the wheel well?? width wise from what i have seen its not crazy. I am more worried about the wheel being 15 inches, i know i seen one but it was 15x6 and this is strictly for 1/4 use

that's what i'm trying to figure out. what is proper back spacing