Sport/Snow button pin outs
 

Hey there. I am looking to use my snow button for a custom switch. Anyone have a diagram showing what wires are for the snow button? Or if a MT could take a pic of the connector to their vsc and trac plug it would really narrow it down as you would be missing wires for sport and snow so I have a 50/50 shot the first try. lol

TIA all.

There are a few in the Kartboy short shifter install thread..

http://farm9.staticflickr.com/8379/8...3caf9270_c.jpg

http://farm9.staticflickr.com/8227/8...89a77bea_c.jpg

http://farm9.staticflickr.com/8392/8...60cf5f75_c.jpg

http://farm9.staticflickr.com/8375/8...108b8d2b_c.jpg

I'll see what else I can dig up.

http://www.ebay.ca/itm/360652427475?...84.m1439.l2648

Just bought this, check pics if you wanna see also. I have a manual brz, but gonna buy this set of buttons and play around to see if I can do the exact same. I am planning on using it for footwell lighting 'snow mode' is set footwell to on with vehicle, "sport mode" is set to on with dome light.
I have no electrical skills so this will be fun. What are you planning on using it for?

Nice, This pic was in the listing.

http://i1115.photobucket.com/albums/...8/IMG_2512.jpg

Fairly sure those are canbus switches so you may not have much luck if any at all getting them to do something else.

Attached is what I could find the FSM real quick... A19 is the TCM.

@finch1750 @joergasm Did you guys have any luck getting them to do something else?

I ended up going a different route as the more I had issues messing with other wiring/control modules I decided not to screw with it.

Oops

Sadly I haven't had time to work mine. No luck, if I was more electrically inclined i'm sure I would have done something. I am now thinking of making that button as a kill switch(never going to use it but figure what the hell)

Sorry for reviving old thread..Just for future reference:
Why don't you use canbus ? Muchh easier and painfree.

I'm actually working on having my exhaust valve open up when the sport mode is activated on my AT. (those catback with varex valve) with combination of arduino, canbus shield and rf transmitter (or relay). It's plugged right into the canbus data 6 pin plug behind the stereo