Side Airbag light with aftermarket seat?
 

Other then the TRD airbag canceller, what other options are there for us? I know we can run without a resistor but I don't want the annoying light or the DIY of blocking it in the gauge cluster.

Anyone?

The resistor works perfectly fine on the drivers side. That is all you need if all you replace is the drivers side. If you do the passenger side the only way to not have it is to remove the passenger seat weight sensor from the stock seat and plug it in.

We folded it up and tucked it under the carpet. The only issue is that it thinks there is someone in the passenger seat all the time and it wants the seatbelt plugged in. I am going to try and turn it off with techstream.

Trust me when I say that is the only way to replace the pass seat and not have a light.

More on my blog:
http://www.jadecrew.com/custom-recar...seats-in-fr-s/

so even the trd option you must use the stock weight sensor and put it under the seat? sounds kinda ghetto. i hope someone makes a kit soon.

what signal does the weight sensor send to that plug? there has got to be a way to trick the car into thinking its plugged in.

I'm no electrical engineer but I would guess if someone can figure out the right resistor to mimic the signal. I know the airbag one is not the same.

Maybe it just needs a completed circuit?

We tried the resistor from the airbag and it fried it. Not sure.

This works. I have one installed and have had no issues.

[ame="http://www.amazon.com/3-3-Ohm-Flameproof-Resistor-Pcs/dp/B0002ZP0US/"]Amazon.com: 3.3 Ohm 1W Flameproof Resistor 10 Pcs.: Electronics[/ame]