FA20CLUB.com Stage 1 ECUTEK Reflash Results
 

Put a kick in the pants for your new daily.....FA20 Club is proud
to release our much anticipated Stage 1 Reflash. This flash develops an increase in TQ and HP throughout the entire powerband. Your vehicle will now be more of what you expected when you signed the papers at the dealership. Some of the features we have enchanced in this tune include:

Increased TQ Limits
Adjusted overall AFR Mixture
Optimized Timing
Optimized Cam Angles
Added 2Step Launch Control
Increased REV Limit
Speed Governor Removed
DTCs for Common Check Lights Removed

With just these minor adjustments to your ecu you are able to gain power without sacrificing the integrity of the original product you purchased. Not to mention the nice over peak gains of 10-13whp. Even on AT transmissions. With purchase of the retail cable we will provide updates to the original purchaser.

FYI: Mustang Dyno numbers are typically 10-11% lower than DynoJet numbers. So our baseline on the A/T FRS would be roughly 154HP to a typical gain of 167HP for comparison to other available products.

We will be continuing to work closely with the community on the forth coming improvements to the EcuTek lineup of features.

http://i1051.photobucket.com/albums/...b/ba6b2148.jpg

2STEP Feature

[ame="http://www.youtube.com/watch?v=JQ2bpxKcpSg"]FA20CLUB FRS BRZ Stage 1 Reflash 2Step Feature - YouTube[/ame]

Price?

Where are you located?

Ft Lauderdale Area....Where in Miami are you located. i might swing down there to the DT tuesday meet once we finish the turbo kit week after this upcoming week.

I went to the fa20club.com web site... what are you playing at, that site had NOTHING to do with EcuTek or even cars?

I would happily welcome more competition is this segment, but when you post a website that isn't yours, I get very suspicious.

thanks for visiting but the final design will not be done until mid week that is the layout im working with at the moment but it is the right site give me some time been working on this tune and dont have a dedicated web designer at the moment unless you would like to volunteer or know anyone who can...?

for now feel free to contact me directly on the board or email

I live about 5 minutes from DT. Let us know when you are going to the meet, I want to see that Turbo Kit! There is a Southeast section on the forum with several Miami/SoFLA threads. You can post more info there. Also, I would recommend a build thread about your turbo kit in here. Those are VERY popular.

Hope to see your car soon!

They do have a FB page.

Fair enough. :) Thanks for the honest reply.

I don't even have a face book account to be able to look at the face book page, let alone any web design experience.

How much more rpm were you able to squeeze out?

Does this tune make the torque dip even worse or is it just me?

Two step on an Auto? Or does some of the manuals also have a "P"ark gear?

Looks like the torque dip widened.... :/

Actually the dip was lessened and it motor also recover from the power loss earlier in the run to the high values. There was only one area in the entire dip that the values were reversed and i found it was related more to the TQ limit table. But since its an A/T i wont want to increase the limits that much on the low end where the transmission shifts without some more testing on the actual affects to the shifting as far as smoothness is concerned. On a manual i dont see that happening since with some spirited driving the shift points would vary more towards the upper end of the spectrum anyway.

When this is finalized, I would like to see it. Id drive down to FtL to check out the tune and maybe get it done if I like it :)

I didn't think anyone in Florida was doing much with this platform

7750rpm is the current limiter for now. Once we find ways to flatten the upper band to actually have a reason to rev high i've deiced to leave it there for now.