FS: FRS Auto Climate Control Conversion Harness
 

This harness is for adapting the BRZ auto climate control into your manual control FRS/BRZ. Can be used for dual or single temp installs, depending on how ambitious you want to be. This is my take on the harness that was the focus of this thread:
https://www.ft86club.com/forums/show...10#post2332310

Price: $350 Shipped in continental US
4 harnesses are available
I will also be including basic installation instructions for the harness and the parts for single temp.

The single temp install is “easy” and does not require any major modifications, but you still need to remove the center console, glovebox, and dashboard to install all the conversion components.

Dual temp generally requires disconnecting AC and heater core, along with needing to loosen/remove the dash bar in order to replace the HVAC housing with a dual temp unit. *I have not personally done the dual temp install, so there could be more involved.

These harnesses use 18ga XLPE coated wire, covered with PET sleeving secured by adhesive lined heatshrink. White electrical tape just secures extra heatshrink for use during install.

For Single temp, these parts are also required:
Driver side Temperature Servo SU003-02045
Damper Servo SU003-02044 - Verify it has the metal bracket
New Blower Motor Resistor 73533AJ000
Temperature Sensor 73730CA020
Temp Tube 72313CA010
Screws for Servo installation (Order 5) SU003-02113
Auto Climate Control panel 72311CA061

This is sick! I would definitely be interested in a harness if you still have one available.

Yes, I still have a couple available. PM Sent

Bump

Have one left ready to ship

Interested! Let me know if you have one available.

PM'D

hello do you still have the harness for sale?

my email is alexandersaponte@gmail.com