Mini DIY: Zip-tie (GoPro) bar mount for large bars!
 

If you're using a harness bar like BK's for our cars, you will realize that the center section of the bar is too wide for any off-the-shelf bar mount to work. I ended up making a mount with little to no cost.


https://thumbnails-photos.amazon.com...Fh-iYJiH0THNlx
The key is to find appropriately sized zip ties that you can fit within the rails of the GoPro mount. I inserted one side of the top mount piece to its rail first, and then forced the other side.

https://thumbnails-photos.amazon.com...Fh-iYJiH0THNlx
Align your zip ties before you fully insert the top mount, since you won't get to move it once it's in.

https://thumbnails-photos.amazon.com...Fh-iYJiH0THNlx
Ready to install

https://thumbnails-photos.amazon.com...Fh-iYJiH0THNlx
You probably don't need to use the adhesive bottom, but why not; it would reduce vibrations and movements at least..

https://thumbnails-photos.amazon.com...Fh-iYJiH0THNlx
Done!