GR86 Brake Pedal height Adjustment
 

Free mod to bring brake pedal lower. So that heel toe is more natural and because the gas and brake pedals are more level, the sliding of the right foot between the gas and brake is also more natural and smooth.

Probably same as first gen. Just putting here.

1. Loosen (size 14 spanner) jam nut and remove brake switch. This gives more clearance since you can pull the brake pedal upwards out of the way later when you need to bring the clevis out to turn.
2. Loosen (size 17 spanner) jam nut on brake master cylinder shaft.
3. Remove safety retaining pin and pin. Massange clevis out of the brake pedal. Turn in clevis 2 rounds (you may want to experiment with more)
4. Reverse everything above.
5. Remember to adjust the brake switch such that about 1 to 2mm of blue can be seen. Too little and the brake lights wun come on until the pedal is very depressed.

Enjoy heel toeing!