2014 Turbo BRZ - Built Motor PTE6266 - South Florida
 

I am selling my 2014 Subaru BRZ due to me wanting to purchase a ZL1 1LE. Motor was built by IAG Motorsports. Makes 681rwhp on E85 it is still on old tune from previous setup. The current setup is capable of making 700HP+. The vehicle is located in South Florida.

Mileage: 39,936
Clean title
Now: 25k

The Modifications:
- IAG closed deck long block
- IAG Spec 86.25 MM Forged Pistons
- Manley FA20 HD wrist pins
- King XPG Rod bearings
- King XPG main bearing set
- heads have complete ferrea valve train
- GSC Power-Division valve seals
- Closed deck and O-ringed block14MM headstuds
- Manley I-Beam connecting rods
- New timing chain was done along with tensioners, and guides
- Full blown Motorsport oil pan Killer B motorsport Oil Pickup tube
- Full blown motorsports catch can
- Custom turbo kit with a precision turbo - 6266Turbo smart BOV
- Turbo smart wastegate
- Clutch master twin disc 725 series
- Velox clutch fork
- 20 gallon fuel cell w/ two walbro 450 pumps Magna distribution block
- All fuel lines have been replaced with -6 AN Lines, and -8 AN lines
- Aeromotive fuel pressure regulator
- Radium fuel rails
- FIC 1650cc injectors
- 17+ brz intake manifold
- Hoosier radials
- M150 ECU with Motec Jumper harness
- BTI gauge pod
- Oil pressure sensor
- Coolant pressure sensor
- Exhaust pressure sensor
- 4 bar map sensor
- Flex fuel sensor
- Spal fans
- Koyo radiator
- Leg Motorsports Ducktail
- KW V3 coilovers

I do have extra parts as well that if the buyer wants them I will include with the purchase of the vehicle.

Toda oil pump gear
JDL oil cooler
Invidia exhaust
Spare block along with pistons and rods
Klutch rear wheels(to match the front)
black Plastic intake manifold
stock ECU

Sounds dangerous. Good luck with the sale though.

Where are you located?


Sent from my iPhone using Tapatalk

I am located in Stuart, FL

Price drop

Trans/synchros all stock? Also didn't see anything about the rear end - axles/diff stock?

Yes stock transmission, axles and diff

Open air dump pipe out the front.
So full on race car and not road legal then?
Or do you have another dump pipe that hooks back up to the exhaust on the side?

Dump pipe out the front. I do have a invidia exhaust that will go with the car but will need a downpipe made if you want to use it. As far a road legal I have no issues here in Florida.

Final price drop