Harness Mounting question
 

Hey all,



So I purchased a 6 point sparco harness that uses clips for the lap belt. I am using a PCI Racing seat plate which has a mounting hole for the tunnel side lap belt, and I'm hoping to use the stock seatbelt's mounting point for the outer side of the lap belt.



Is there a solution for this without drilling, and then using eyelets and a backing plate? I already have a roll bar so the car has plenty of holes in it, but it looks as if the tunnel side has fuel lines running where the eyelet would need to go.



Should I just sell it and get a harness that doesn't use eyelets / clips?



Thanks - here's some pics that may help also.

Kinda confused what you're asking, but undo that bolt that you've got an arrow to and replace it with your eyelet.

For the sub belts you wrap them around the center section of the seat mount that has 4 bolts attached to it, assuming your harness doesn't have the clips sewn into it, otherwise you'd have to drill / backing plate for them.

Remember to cotter pin your harness clips too.