| baretmm |
07-07-2021 04:31 PM |
crank no starting, no rpm signal
I have a 2013 scion frs m/t i had a spun bearing and I replace the short block with a new one but now only crank but no start and when I use my scanner too see what is going on I see I don't have a crank or rpm signal I change the sensor check the harness and check the plate all that is good but it won't get any rpm signal, but also if I spray start fluid will start idle really rough for less Then 5 second and died I don't know what exactly anyone know or maybe someone the run to this same problem what may be.
|
