Ecutek how to get sd to work
 

Sd blend stays at 0 I have the blend map set to all zeros
sd flags goes from 12 to 15
I only have the maf gs trigger set to 400 , 390
other trigger are zeroed

remove all the triggers
Just use SD blend zero all the triggers


see if it works no ral need for trigfers as the sd blend works of manifold pressure once it gets to positive pressure ie over 1 bar jusr set SD



the trigfers often work as a value and a hysterisis


eg the load trigger you set say 0.7 load with hysteresis of say 0.1


im guessing the maf g/s trigger some same way so if you set 400 and 390 its not going to work well

Will do.
Thanks

How do I know that it is using sd?
Ecutek gave a trigger example of 5000 , 4950 rpm

log sd real maf, sd final maf and the other one, something like sd corrected maf

with full sd, final maf will be same as sd corrected maf
remove all the triggers like stevy said and just use the blend table and remember to enable SD, it s a separate table to check