grimmspeed ebcs brz install????
 

Dear all


I need good setup

For grimmspeed EBCS
WITH EXTERNAL WATEGATE
WITH BOOST GAGE



car tuned by ecuTek



What your recommendation for

Port 1.2.3


And where I have to put the T for boost gage



Thanks

I put the T for the boost gauge before the bump in the line ( T goes on the engine side) going to the brake booster.

These can be confusing, but I have mine set up so the port on the FRONT is going to the compressor housing, the port on the left (EBCS oriented with the front port facing you and the ports on the bottom half) connected to the wastegate. 3rd port ( on the right) has a muffler on it.

Mine is NOT a branded Grimmspeed EBCS< it is a Mac 3 port valve

Can you please explain with diagram or image

https://i.imgur.com/V8GA1O5.jpg

WG - WASTEGATE
T - Turbo compressor housing.


I don't have a photo of where I tapped for boost gauge. Start at the brake booster and work your way down the vacuum line. 4" in you'll feel a hard piece. 1" after that is where I put a T

https://i.imgur.com/IixgN0i.jpg

Just got done work. Here's one fresh from the garage. Be sure if you use a T to try and get a tapered T fitting.