p0030 issue A01I
 

Dear all

I have install aftermarket header for someone
2014 auto FRs. ...

ZA1JA01I

After few minutes engine light came
P0030
I have tune it stage 2 with Ecuflash
I disabled p0030
And all related o2 codes
But still keep coming even the code disabled from the map

What I can do
It take around 10-15 to show up

I return back to stock rom
When I turn switch on immediately cel show up same p0030
Crouse control stop
Sport mode disable
Gear changed hardly even I but it to manual mode

I have changed both O2 sensors but still same issue

Any idea??

Thnx

Find the definitions for B01 and see if it comes on. If it only comes on when you flash the car, it's something with the map

B01c for manual


I use Steve xml for all my flashing

One for auto

One for manual

It's show up after some time


But after flashing to stock show up immediately before even drive it

Are you sure the sensors are plugged into the right connectors? Have you tried switching them for fun?

R u sure :slap:

Basic troubleshooting starts with physical first. Good luck then.

either is a electric link fail on the connector, or you damaged the sensor while installing in header, they re pretty fragile

I have changed both O2 sensors
Also I have returned to stock header

With stock rom but still same issue

This happened after installing aftermarket header and off stage 2 tune



I return everything to stock but still same 😭

Which one??
Location??
Photos if possible:search:

Thnx to all

It was 15amb fuses

"It aint got no gas in it" "ummhuh"

I guess you guys are too young to get that.
Its from a movie called "sling blade"