Car won’t start after turbo install.
 

I installed a jdl turbo kit with delicious ebc on my brz and now it just cranks over. It ran for about 10 seconds then died. I’ve looked over everything and can’t seem to think of what would be wrong. It is throwing an evap code. Anyone have any ideas?

is the fuel pump priming?

Switch the MAP sensor back to stock, make sure your pcv and crankcases lines are all hooked up correctly

Fuel pump is priming and I’ll try the stock map sensor. Double checked all lines and everything seems to be good.

of course remember to change the scaling of the map sensor on the tune, if you have an higher Bar map now
otherwise it will not start again

Is everything reinstalled? You didn’t remove the ECU on the passenger side of the engine and leave it unbolted, did you?

Car fired right up with the stock map sensor. Thank you guys for the advice. Would it be safe to drive the car home on the stock sensor if I kept the rpms low so it doesn’t build more boost than the stock sensor can handle? My tune is from delicious so I’ll have to call tomorrow if they’re open.

yes just stay out of high boost
what sensor did you have before?

I have a 3 bar that cane with the kit

if it started with the stock map without a modification in the tune, that s your problem
didn t you tell Delicious you had a 3bar map?

I did tell them when I ordered it, I’ll have to give them a call and see what’s going on.

Does your tune file say 3-bar in the script? Mine said 4-bar, and said 220cc then 770cc and said flex fuel, as I added those components.

https://datazap.me/u/jirace/v8-flex-...?log=0&data=29

Look at my files from DataZap.

if it started with stock map that means surely 10000% they forgot to scale for it