Driveshaft/pinion flange bolt specs?
 

Would anyone possibly have thread and bolt length specs for the bolts that fasten the driveshaft flange to the pinion flange?


I need to pick up new (longer) hardware as the flange on the end of my DSS aluminum driveshaft is a lot thicker than the stock piece so the bolts are a bit short.

Unfortunately, my car is parked (a few hours away) at the track and the hardware supplier is here in town :(


Thanks in advance for the help. Fingers crossed someone has their out!

Found the answer in this thread for anyone else in the same situation:

http://www.ft86club.com/forums/showthread.php?t=110710


It didn't come up in the search here, but I found it through an outside search engine :)

You don't need the washers. Just threadlock and tighten to spec.