clear sidemarker is getting loose
 

I bought a clear sidemarker about an year ago from amazon and now it starts to getting really loose and pop off time to time everytime I fixed. Should I just buy new set of clear sidemarker from ft86speedfactory since they are claim that their fitment is same as OEM from factory. It's kinda expensive ($95) but if it is truly the OEM factory fitment then I might consider buy for it. Thank you in advance!

Get some 3M sticky pads on that sucker

Or hot glue gun

First off, thank you for saying loose and not lose. :bonk:

Next, I used a writeup @zeal86 wrote. Essentially you drill a hole in the plastic housing of the light then use a small gauge wire to tie a knot at that spot and run the wire to a hole off the frame. I used a wire to make a loop then I used zip ties so I could cinch it tight. It worked perfectly.

I had Helix for 3 years before they split in half, and yes the JDM ones have MUCH better fitment and a nicer material. When you tap on the plastic you can tell it’s OEM.

By having a better fit, it’ll put less stress on the notoriossuly fragile A clip and you’ll have them looking fresh for much longer.

PS, I think I drilled two holes like a front and back thing to get it to sit evenly.

http://www.ft86club.com/forums/showthread.php?t=119974


@zeal86 This is his writeup.