OEM Bump Stop length
 

Can anyone please tell me what the OEM front and rear Bump Stop lengths are? I tried researching and found fronts are maybe 60mm?

I think I have some in my shed I can measure. I'll look tomorrow and get back to you.

Ok, I have them. What need you need for measurements?

I can measure front RCE short bump stops if you’d like.

I just need overall length of front and rear. I have some koni that I’m installing but want to purchase some aftermarket bump stops to test.

Measured the stock ones I took off at about 20k miles to install the RCE yellow springs (they include new stops).

Front is about 57mm, and rear is about 59mm. Not sure if these have compressed a little during use.

I have just the opposite. Front is 59 and rear is 57mm.

I also have 2 RCE whites and one RCE blue for sale if you want them. The other RCE blue was cut up. For Science!

What are the whites and blues?

Oops my bad. I meant RE Suspension
http://resuspension.com/index.php/bu...ot-series.html

Oh I see. RCE likes to color label their springs blacks, yellows, grays (ok I made up grays, but that’s the color of the tarmac springs lol)

What’s the ID of those? I would think there’s a big difference in shaft diameter between front and rear

Yes there is a big difference. They would need to be drilled out.

Oops - you are right... I had them mixed up. Front is 59+ and the rear is ~57 including the 4 nubs ~55 without. Front ID is 21.5~, Rear is ~15.3