Toyota Airbag Logo for Stock Wheel
 

Inspired by http://www.ft86club.com/forums/showthread.php?t=20938 This is actually reusing the same OEM Toyota badge as the others in that thread, I just did a mesh backing that is more similar to the current Toyota models.

In the end I removed this and made a Batman logo, so this one is available. Once you remove the scion emblem if sits nicely in the recess of the airbag and looks pretty good. Adheres with the included 3m adhesive.

My asking price is less than I have invested in materials. I would just would hate to chuck it if someone will use it.

$15 obo shipped in the continental US.

I was asked what this looked like installed and this is the only pic I have, I took it while I was test fitting so it's a bit crooked.

https://uploads.tapatalk-cdn.com/201...e2ff786df1.jpg

How would I go about removing the Scion logo, I actually want this. as I don't want to spend around 425 just to switch emblems on the air bag...

I used a small pick and just pulled it off piece by piece. It has some little tabs holding it into the airbag cover.

do you suggest I take off the battery connectors before attempting to pry at it? and you said "pick" what pick o.O

I'd recommend removing the horn relay so you don't have to hear it go off, but you're not being any rougher on the airbag than when you honk your horn.

You know, a pick. Like the dentist uses to scrape shit out your teeth.

Someone give me $10 for this thing and I'll be in the post tomorrow. Otherwise it's going in the garbage.

haha before you said a dentist one I was picturing:

https://www.jimdunlop.com/images/jim...73033.MAIN.jpg

I'll buy it for 10 bucks?

SOLD