Looking for Project Kics Experts.
 

I've finally narrowed down my choice of wheel fasteners: Kics R26. The only caveat is they're open ended, which brings me to my question…

Will R40 Iconix/Revo caps fit on R26 lugs?

I'm on OEM studs and going with an 18×8 +45 wheel. Will this leave enough thread on the R26’s to accept the cap?

Thanks in advance!

P.S. Yes I've searched (and searched, and searched some more).

I vaguely remembering seeing on a merchants website that the R40 caps will not fit R26 lugs. I'm running r26's tho and there's minimal debris that actually gets stuck in the threads, I wire brush the studs everytime my wheels are off anyways.

No, iconix and revo have a lip on the inside of the lug nuts to hold the cap in. It is also why you can't run extended studs with iconix/revo but you can with r26 and r40.

This helps a lot. Even as a vague memory it helps that someone out there may have tried. Thank you.

After all I'm sure merchants/manufacturer would advertise the fact if they were compatible.

Iconix caps are threaded & Revo's are clips. So Iconix will accept extended lugs. Still helpful though, thank you.

http://uploads.tapatalk-cdn.com/2016...a825c3dc85.jpg

http://uploads.tapatalk-cdn.com/2016...ccc68f38c1.jpg

I know someone that got his revo stuck on his extended studs.

I agree with you that Revo's cannot be used with extended studs, only the iconix/R26 (not personal experience though, only research).

It will not work. Have tried this before and they do NOT work!

Looks like the search continues, thanks again for the info everyone!