How do I remove this bolt o.o?
 

Hey guys,

Okay so this bolt is attaching the wheel well and the front bumper. Since our wheel well is made of plastic/rubber....

Here is some pictures. I tried a Philips screw driver and a ratchet (10mm) but both don't work as it ruins the wheel well.

Do not worry about what I am doing please.

https://s32.postimg.org/kah2lex81/IMG_1620.jpg

https://s32.postimg.org/n5u5sa181/IMG_1621.jpg

Also at 2:28 of this video. This guy is removing the bolt easily with a philips. However, when I do it with a lost of force. It turns the whole wheel well...



Also as I was taking the wheel well... few washer fell off. Anyone can tell me where it goes. It came from the front. If you need more description. Let me know.


https://s32.postimg.org/fedftpx2p/IMG_1622.jpg

It seems alot of people have issues with that one, I haven't it sort of just unscrewed out of its hole. I think someone else here just drilled it out and found push pins online to replace the bolt with.

is the bolt necessary to remove when taking off the bumper? I don't remember removing it when taking off my bumper, but if I did, it didn't give me any problems at all. have you tried some pb blaster?

You might try using a pair of vice grips and pull down on it as you are unscrewing it.


humfrz

Most likely it's rusted to the U Nut on the other end that's what you're experiencing, lube it up because you might tear the plastic, but you might have to and just DIY a fastener after your project is done but I don't have the bolt there anymore and it holds up fine for regular driving.


Sent from my iPhone using Tapatalk

http://uploads.tapatalk-cdn.com/2016...85da5b7d51.jpg

That's basically whats on the other side


Sent from my iPhone using Tapatalk