RomRaider/ECU Flash help
 

Anyone have experience with ROMraider or ECUFLash that can help me get this to work? I just want to make sure i am doing this right. I dunno if its because it's a 2016 but I can't seem to get it to show the ECU info to change parameters. I live in Camden County but wouldn't mind traveling to someone not too far.

Thanks!

suggest you read the Tactrix link below


read out your stock rom.
save the file as a .bin


if its a 2016 manual its likely ZA1JF40C


open it with a hex editor and search for "ZA1J" you will then find your calid

I was able to save it as a bin but when I try to open it in RR it says ECU definitions not found. But I have the latest defs, I think.

My CALID is ZAJ1F00C

post up the bin and ill have a look


did you point romraider to the definition file ?

Yep, the last one is 32bitbase and there is another from 2009 I tried both.

Here's the BIN

OK its a ZA1JF00C rom :-)




note romraider and ecuflash defs are different and not interchangeble


need 32bitbase and ECUFLASH defs for ECUflash


and romraider defs for romraider


don't mix them up does not work.


also beware of the OFT calid changes post up the rom your going to flash and ill check it

So should I put both the 32bitbase and ecu defs in the BRZ folder in romdata folder?

Put them in directories as per the Tactrix thread link below


remove any romraider defs from ecuflash directories

I know they are separated but I'll check.

@stevesnj if you've read the rom then EcuFlash is fine. You just need now a RR ecudef file. see this thread from RR http://www.romraider.com/forum/viewt...hilit=ZA1JF00C

You can put the file in any location, your desktop if you wish. Then open Ecu Definitions -> Ecu Definition Manager window, click Add and load the saved file, click Save.

Now you should be able to open your rom.

PM me if you need help, i'm maybe 20-30 mins from you

Awesome yes! I'd appreciate the help. where u at in NJ?