3 BAR Map Sensor Scaling
 

Can anyone can tell me step by step how to scale in a 3 bar map sensor? I can't find any on how to do it. Thanks

I assume you are using something other then ecutek? As in the help files with ecutek there is a walk through for rescaling a map sensor.

I am using ecutek. Did not know about the walk through. thanks

If this is your first time using the software I would recommend reading all the info they provide in terms to this application. It will make life much easier for you.

Anyone know off hand?
 

Anyone know the omni 3 bar map scaling for V/PSI, versus bar?

I've done the calculation of what it should be, just want to make sure it's right.

Jaden

For Google / future searches.

Omni 3 bar:
Multiplier 0.617 / Offset 0.03

Omni 4 bar:
Multiplier 0.825 / Offset 0.031

that is for bar...
 

that is bar/V. I'm looking for psi/V...


I've done a manual conversion, just making sure that that is correct...


Jaden

Got it working thanks

This was in reply to OP. The values I posted are what is required to enter in to Ecutek regarding aftermarket MAP sensor scaling.

As for your question, I'd recommend making a new topic since its not related to OP's question at all.

Are you serious?
 

It's a thread for omni 3 bar map scaling. I can just use the manually converted figures, but someone saying yeah here's what they are in psi/V does not necesitate starting another thread...

Do you know them? If you do that was ridiculous because you could've more easily just posted them than your stupid request that I start a new thread requesting the SAME thing in a slightly different format.

Jaden