Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB

Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB (https://www.ft86club.com/forums/index.php)
-   Electronics | Audio | NAV | Infotainment (https://www.ft86club.com/forums/forumdisplay.php?f=27)
-   -   Wiring dash cam for rear window (https://www.ft86club.com/forums/showthread.php?t=107137)

xFury 06-14-2016 10:41 PM

Wiring dash cam for rear window
 
Hey everyone, I'm planning to get another dash cam to hook up to the rear window, how would I go about wiring it?

Currently the front window dash cam is plugged into my cig lighter and comes on when I go to acc switch, how would I make it function the same?

Thanks!

ryoma 06-14-2016 11:03 PM

if you want a simple solution, get a dual USB charger and put it in your glovebox. run both dashcams to that charger and hide the lines. you will need to run your rear wires through the head liner.

adtsoft 06-15-2016 04:33 AM

Pop off the trim above the glove box and wire from there. There is lots of room behind that panel, it is where I stashed a Sirius receiver with plenty of room to spare.

ryoma 06-15-2016 04:14 PM

I ran my dashcam through the headliner to the passenger A pillar and down the door sill partially (tucked wire behind the rubber strip) then through the side of the glovebox. there is a panel on the side of the glovebox that pops right off and it has a hole that leads into the glovebox. the panel goes back on without clipping any wires. easy job, though getting the A pillar trim back on was kind of a pain until I figured out there was a hidden clip

tracerit 06-16-2016 06:00 AM

Is there an airbag behind the front A pillars and rear C pillars? I'm thinking about running wires through them to hide both dashcam and rear high mount brake light but concerned about compromising the safety of the passengers (well just the front since no one can fit in the back lol).

ryoma 06-16-2016 03:45 PM

Quote:

Originally Posted by tracerit (Post 2682019)
Is there an airbag behind the front A pillars and rear C pillars? I'm thinking about running wires through them to hide both dashcam and rear high mount brake light but concerned about compromising the safety of the passengers (well just the front since no one can fit in the back lol).

there's an airbag behind the A pillar for sure, not too sure about the C pillar but I would assume there to be one too since it's pretty close to a person's head if they sit in the back. with the force that an airbag has when deployed, I doubt a few wires will hold it back. if anything, it will rip the wires out and possibly your dashcam too when it deploys lol.

FX86 06-16-2016 05:10 PM

i didn't even bother hiding the cables to my rear dash cam..it's not like i have passengers in the rear so i just threw the wire into the back seats

SmartedPanda 06-18-2016 07:40 PM

I have a blackvue + magic pro.
I ran the rear from the glove blox. Get a splitter for the lighter output.

Pop open the trim on the passenger side, and route it up the passenger front pillar through the rear, and it all tucked within the rear head liner.


All times are GMT -4. The time now is 07:48 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2026 DragonByte Technologies Ltd.


Garage vBulletin Plugins by Drive Thru Online, Inc.