Installing stock map with ecutek and removing license
 

HI, I am getting ready to put a stock map back onto my BRZ using the ecutek license and cable. Can someone guide me to as what the steps would be to do this? Also is there a way to remove the ecutek license from my ecu?

From my understanding there is not a way to remove the license from the ecu. You load the stock map just like you loaded your custom tune.

ok thanks for the response, also i did not load the custom tune but i cant imagine it will be very difficult. I will give it a shot this weekend.

nope not hard at all if you have any experience at all with it on any platform.

Just use the ecutek system to flash the appropiate "stock" map thay is stored in the maps folder with the ecutek software. Flashing one of those 'stock' maps with no ecutek features enabled will also remove the ecu lock.

The ecutek licience is still embedded in ecu, you dont rearly need to remove this and you actually need it if you want to flash with ecutek again.

If you rearly want to remove the ecutek licience and have a 100% byte for byte stock rom you would need to reflash the ecu again with tactrix\ecuflash and use as stock rom from the link below