My Racer X / Setrab oil cooler install
 

My parts:
Setrab 9-series STD 15.94"x4.53" pn: 50-915-7612
Setrab brackets pn: 23-9002
Setrab adapters AN10 - M22 pn: 22-M22AN10-SE
Racer X Fabrication thermostatic sandwich plate, no finish pn: 02004X-AN-RAW
fitting at plate: Summit Racing AN10 o-ring to AN10 flare adapter pn: SUM-220164N
hose: 2 x 3' AN10 black nylon hose, Summit Racing pn: SUM-240003B
hose ends: 3 x Russell Endura AN10 90degree, nickel finish, pn: 610181
1 x Russell Endura AN10 45 degree pn: 610111

some parts pictured:

http://imgur.com/eJNbiha.jpg

More to come . . . . . out of time, just now!!!
Please, NO comments until I have finished!!!!

First

Well, I am having a hard time getting my images I stored in imgur to show.
More patience, please. (maybe my efforts to share are resulting in too much trouble to continue)(we'll see....)

Here is the 90 degree hose end:

http://i.imgur.com/IX9Dknn.jpg

I chose the Setrab 9 series cooler. I did not want to mount it on the plastic shelf behind the bumper. I wanted securely use the manufacturer's brackets, and mounted it on the back of the collision bar. I had a friend make these brackets from aluminum:
http://i.imgur.com/sKI2rIs.jpg

Bumper removed:
http://i.imgur.com/8AiHwKy.jpg

Collision bar removed:
http://i.imgur.com/UsmSVXw.jpg

Showing the spacing for the mounting holes using the Setrab bracket as a guide:
http://i.imgur.com/oxRfLJm.jpg

Here is a shot of the collision bar with all for holes drilled to accept rivet nuts:

http://i.imgur.com/70CbZy1.jpg

I sprayed some paint in each hole edge to help deter corrosion. Here is one rivet nut installed, followed by all 4.

http://i.imgur.com/AsUsyUv.jpg

Here is the Setrab w/ brackets mounted to the collision bar with my custom-made brackets.
http://i.imgur.com/JnL6lqF.jpg

and bar mounted:
http://i.imgur.com/Iyq7cnn.jpg