Omni 3bar map sensor values for ecutek
 

Wondering if anyone can provide the values I need to install the Omni 3bar sensor with an ecutek. I've been searching for days with no luck. Thanks for the help!

Sent from my D6708 using Tapatalk

Use at own risk :-)


MAP Scalings for Alternative MAP sensors for Boosted cars (Manifold Pressure Sensors)


Omni 2.5 Bar MAP

The OFT300 (Vortex supercharger) map uses the 2.5 BAR Omni and has CEL-P0068 disabled in the map
ok for 2.5 Bar OMNI MAP sensor ECUTEK scaling in BAR

Manifold Pressure Sensor multiplier in bar per volt. = 0.500
Manifold pressure sensor offset. Value is measured in bar. = 0.100
MAP Sensor voltage max = 5.0v
MAP sensor Voltage min = 0.0v

Omni 3 Bar MAP Sensor (Metric in Bar)
0.617 - MULTIPLIER
0.03 - OFFSET
scaling limits 0 - 4.75v

Omni 4 Bar MAP Sensor
Manifold Pressure Sensor Scaling - (imperial PSI)
Multiplier - 12.087
Offset - 0.168
Metric/Bar

bar/volt .833
offset (bar) .012

Manifold Pressure Sensor Limits - (CEL still comes on )
High Input CEL Above - 5.00v
Low Input CEL Below - 0.00v
Disable CEL P0103 and P0068

Thank you!

Sent from my D6708 using Tapatalk

The offset for the Omni bar3 is supposed to be 11
The offset for the Omni bar4 is supposed to be 31

Is that in bar or psi ?

I haven't had to disable the CEL...
 

I've been running the omni 3bar and haven't had to disable any CELs so far. I've ran it for a couple of months.

Jaden

Do you mean .11 and .31 or 11 and 31?

Sorry for the long reply, this is directly from the Omni power website . there is no information regarding if it's metric or not unfortunately I'm still trying to track down what the proper conversion would be

What values did you use?

.03