Tail as Turn by Diode Dynamics EDM REPIN (DIY)
 

Hi mate, this is the easiest way to install the "FR-S / BRZ Tail as Turn™ +Backup Module" on EDM/JDM grade. http://www.diodedynamics.com/store/c.../category/666/


You need to repin the harnesses this way to obtain same results of USDM tail light.

Thus in Europe, we cannot delete turn light, you can preserve this option connecting the two ends of black wire togheter. Therefore, "backup" add-on is not necessary.

Here there are two videos of "FR-S / BRZ Tail as Turn™ +Backup Module" installed on Crystal Eye EDM wiring.

For running light flashing you need to reverse wiring on EDM schema.
Yellow and red wires need to be repinned again in reverse order.

Mine is with TapTurn option.

When press brake with turn, tail returns to stock operating way. No flash of running light (boomerang) on Crystal Eye.

This procedure might be done on Tom's tail light too. Remember that in all schema you will try, Black wire is turn, Green is Ground. One end of black wire will receive 12+ "outside Diode Dynamics one-end module".

http://imagizer.imageshack.us/v2/128...633/ti1e0e.jpg

http://imagizer.imageshack.us/v2/128...633/5SZpiI.jpg

http://imagizer.imageshack.us/v2/128...903/hIPCYr.jpg

ORIGINAL DIODEDYNAMICS WIRING USDM

http://imagizer.imageshack.us/v2/xq90/910/Wlrwdl.jpg


Some video
[ame="http://youtu.be/GbI2sfJwMXM"]http://youtu.be/GbI2sfJwMXM[/ame]

[ame="http://youtu.be/KSOOVrjyTQw"]http://youtu.be/KSOOVrjyTQw[/ame]


WARNING:
ON STOCK TAIL
YOU NEED TO REPLACE TURN BULBS WITH LED BULBS , FLASHER HIGH CAPACITY (IMPEDANCE) NEEDED