Backup camera on 2013 with Kenwood HU
Hello all, I been racking my brain on installing this camera. I am good on the reverse signal (pink wire in kick panel) that gets added to pin 2 on the 28 pin connector. What im confused on is the 6v power source for the camera.
this is the kit I got https://camerasource.com/automotive-...amera-kit.html I have a Kenwood DNX6904 with a Maestro RR already installed. I cant seem to find the blue/yellow wire from the maestro that supplies the 6v signal to the camera. Is it on a sub harness that is not plugged onto the RR? I assume that will go to the red wire on the camera, and of course the black will be a ground. this thread helped a little https://www.ft86club.com/forums/show...5&postcount=20 Other forums seem to agree that there should be a 6V blue/yellow wire on the RR, I cant find it Thanks for the help JC |
Looking a little deeper, it appears that the TOY1 harness kit comes with what i need.
I have the same setup in m wifes Forester and I dont remember going through this, then again, it already had a camera |
All times are GMT -4. The time now is 11:48 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by
Advanced User Tagging v3.3.0 (Lite) -
vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.