Clutch master stage4 anyone
 

new flywheel+6puck disc clutch kit installed
there is a lot noise during depress or take my foot away from gas. chattring or grinding noise coming around 3000-3200RPM and a lot noise if the gear in fifth gear on low rpms and also accelerating on high gears noise coming.
and in stopps chatter noise if I press in clutch it gose way :(:mad0260:

Yup.

Don't ride that clutch at all... And keep it in higher RPMs and it will stay quieter.

All normal.

Sent from my Nexus 4 using Tapatalk 4

What did you expect with a pucked clutch?

what about break in period? no need sense its race disc? if it dose how many miles ? also can I race the car around 4000-5000rpm without drag hard lunches yat?

There is no organic compound to break in. Pretty much good to go. Clutches like this are on off... No in between. Anytime you hear a squeal while on the clutch you are hurting it. Good luck :)

Sent from my Nexus 4 using Tapatalk 4

I understood but in my experianse Clutch masters pucked discs less chatter then ACT? and I heard its even worse if I go 4 pucks..

ohh man looks you like it same as my friend dose. he told me this is the real sport :sigh:

I don't care but I been fighting the car druing parking or pull it from the garage

I found the clutch very easy to drive in comparison to other setups I have had to deal with. the chatter did not seem all that bad to me, especially compared to twin and triple disks. An aggressive clutch will chatter some. Adjust your engagement point on the clutch peddle may make it easier for you to drive and get used to.

hope soo yeah I think I need minor adjustment because I have to rev it a lot to move it specily in traffics if I didn't I get it stall and people flashing horning on me:bonk:
in my experience this way better then my other car 350z with OS Giken super single clutch i remove it it was so super hard to drive with hard pedal feel and damn it was unsprung stuff it make my car hardly shacking on tranny to move the car!!!:mad0260:

I with out a dought hate all super single clutches. I will not offer them to my customers. also keep in mind you have a lighter flywheel, with that you have less inertia to get you up and moving so revving it up a bit more will be needed.

alright thanks sir..!:thumbup:

I have the ACT flywheel and 6 puck, and the only noise I ever hear is at idle with the A/C turned on. If you are getting that much noise, there is a chance that your throwout bearing was installed improperly. You might try and pull the tranny back out and grease the heck out of it, otherwise accept it and enjoy your new found FBM power. I didn't worry about breaking mine in either.

are you sure man :confused0068:goin long work pull it out are you sure about that man the shop they doing a good job they legend of Japanese cars are you sure a about that it need a grease or something wrong?

yeah noise it getting worse if I let off the gas around 2300-3000rpm and same and yes while A/C on the noise coms in and if I press in clutch it gose way

the worst part is when I let the gas off while crusing around 2000-3000rpm sounds like almost same on this video skip to part 1:00 liston caruflly that what happen almost same its damn deep noise if I let of gass check please [ame="http://www.youtube.com/watch?v=UiqKgLB-X5w"]scratching noise - YouTube[/ame]

this car dose it while he accelerate min Reversed it happen to me if I let the gass only around 2000-3000rpm please someone help:confused0068:

some people confirm it as Whining noise its also same think happens here min almost same 90% [ame="http://www.youtube.com/watch?v=YpLLImMVuyc"]'90 Mazda miata grinding noise when slowing down - YouTube[/ame]

any help??

Only time my Clutchmaster FX400 makes noise is on deceleration,...never at idle or under acceleration.....hope that helps.

yeah sounds like deep or very noticeable noise while deceleration almost same as the video I post is that right? :w00t:

The fx400 will chatter at idle, with the a/c on at stock idle settings. If you increase the idle (as some tunes do) it may help remedy it. The only time I have noticed it on decel is if it is in neutral or the clutch is depressed.

My fx400 makes a racket in fifth as well when decelerating until about 35mph then it stops. Clatters at idle with the a/c on and u need to rev it to get away from a light in a somewhat smooth fashion.

wow looks like even u we matched :slap: sounds like common for FX400 Clutchs:burnrubber:

its just common for those clutch thanks im happy now i was almost pulling gear down agine :D