follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Delicious Tuning
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results


Page 1 of 4 1 234
Showing results 1 to 30 of 92
Search took 0.39 seconds. Search: Posts Made By: Jajanken86
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 11-20-2021, 10:05 AM
Replies: 41
Views: 6,457
Posted By NoHaveMSG
Depending how much of a hurry I am an and which...

Depending how much of a hurry I am an and which side is off I like to keep it within .2 degree. You won’t see significant camber wear until you are at or over 3 degrees.
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 11-16-2021, 10:36 PM
Replies: 41
Views: 6,457
Posted By strat61caster
Weight isn't a big deal, less then a tenth of a...

Weight isn't a big deal, less then a tenth of a degree difference in camber and not noticable in toe at all unless you're at extreme heights.

Roads aren't flat, they're crowned to allow water to...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 10-31-2021, 12:14 AM
Replies: 41
Views: 6,457
Posted By Ultramaroon
Call Trackside Motorsports. Garth and crew are...

Call Trackside Motorsports. Garth and crew are worth every penny for the special touch. I am notoriously distrustful of "professionals." He's willing to put up with my annoying questions, and I am...
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 10-30-2021, 06:00 PM
Replies: 11
Views: 2,781
Posted By gen3v8
I seriously think any cleaning will not work...

I seriously think any cleaning will not work well. The original finish is probably damaged/ scuffed from some preparation prior to the white. Best bet is removal proper prep and recoat
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 10-29-2021, 11:41 AM
Replies: 11
Views: 2,781
Posted By NoHaveMSG
It wouldn't hurt to try. We use WD to remove...

It wouldn't hurt to try. We use WD to remove sticker residue, but I don't know if it will be able to cut paint that has been cured. MEK may work but I would be cautious with it. For touchup we use...
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 10-29-2021, 12:09 AM
Replies: 11
Views: 2,781
Posted By soundman98
the concept there is that the lubricant is...

the concept there is that the lubricant is getting between the layers of material. paint applies differently from plastidip, so it really shouldn't work for paint.

i can't think of any process i...
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 10-28-2021, 08:16 PM
Replies: 11
Views: 2,781
Posted By NoHaveMSG
Paint stripper will be too harsh if it is powder...

Paint stripper will be too harsh if it is powder coated. You may be able to use a light solvent, but it may discolor the original coating.
Forum: Want-To-Buy Requests 11-09-2020, 09:58 AM
Replies: 2
Views: 426
Posted By gcranston
Dude, camber bolts are $25. Don't bother with...

Dude, camber bolts are $25. Don't bother with used ones.
Forum: Northwest 10-08-2020, 06:35 PM
Replies: 2,457
Views: 580,545
Posted By sachu
Was gonna say, i had a set of 17x9 wheels i would...

Was gonna say, i had a set of 17x9 wheels i would have let go of if you were still looking.

720Form GTF1
Forum: Northwest 09-10-2020, 03:10 AM
Replies: 10
Views: 1,268
Posted By rice_classic
I 2nd the comment about a cheap set of wheels and...

I 2nd the comment about a cheap set of wheels and a set of proper winter tires. Ideal scenario if you can swing it.
Forum: Northwest 07-16-2020, 03:42 PM
Replies: 6
Views: 1,055
Posted By Seiryuu
If Costco carries the tire you want, I would wait...

If Costco carries the tire you want, I would wait for it go on sale (they alternate brands like every month). Then take a scrennie of their final price and show to Discount Tire (America's Tire) for...
Forum: Mechanical Maintenance (Oil, Fluids, Break-In, Servicing) 06-22-2020, 10:54 PM
Replies: 10
Views: 1,417
Posted By soundman98
why bother with a messy intermediate step? get...

why bother with a messy intermediate step? get the hose adapter to drain the oil directly into the jugs...
...
Forum: Issues | Warranty | Recalls / TSB 11-03-2019, 12:47 AM
Replies: 9
Views: 1,720
Posted By norcalpb
It’s only meant to align it. But you gotta do it...

It’s only meant to align it. But you gotta do it manually now.
Forum: Issues | Warranty | Recalls / TSB 11-02-2019, 08:12 PM
Replies: 9
Views: 1,720
Posted By Mr.ac
Dude. Sorry you just totaled your car.

Dude. Sorry you just totaled your car.
Forum: DIY (Do-It-Yourself) Guides 12-21-2018, 01:01 PM
Replies: 240
Views: 127,211
Posted By churchx
If you like travel & bite point as is - no....

If you like travel & bite point as is - no. Spring just makes a bit easier to press clutch pedal. Removal of it - just harder to press clutch (but thus also easier to "feel" bite point).
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 11-06-2018, 03:07 PM
Replies: 401
Views: 177,004
Posted By churchx
There is no "best" for everybody. For better...

There is no "best" for everybody. For better advises/suggestions worth first stating your wishes/expectations/goals/budget more detailed. That will affect what should be done, to what extent, and how...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 11-06-2018, 12:59 PM
Replies: 401
Views: 177,004
Posted By churchx
Jajanken86: there are examples to both good and...

Jajanken86: there are examples to both good and bad. Eg. good performance alignment may add to car's handling. Some tire/wheel choices for sake of looks may decrease car performance/handling. None...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 11-06-2018, 12:59 PM
Replies: 401
Views: 177,004
Posted By Racecomp Engineering
Good tires (not necessarily the stickiest tires) ...

Good tires (not necessarily the stickiest tires)
ALIGNMENT
A few key bushings (steering rack, rear diff, rear subframe)
Swaybars (reasonably sized for your application)
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 11-06-2018, 12:56 PM
Replies: 401
Views: 177,004
Posted By N234
Sticker tires, Wider tires, Less offset, lighter...

Sticker tires, Wider tires, Less offset, lighter wheels, etc.

Coilovers that don't lower your car!

A little front camber, a lot of front camber, other alignment related...

Driving practice,...
Forum: Mechanical Maintenance (Oil, Fluids, Break-In, Servicing) 10-14-2018, 05:37 PM
Replies: 5
Views: 2,326
Posted By Ultramaroon
The second one is twelve better.

The second one is twelve better.
Forum: Northwest 09-12-2018, 02:46 PM
Replies: 2,457
Views: 580,545
Posted By NickB34
Stop trying to sell it. I picked one up for free...

Stop trying to sell it. I picked one up for free since my car didn't come with the stock parts. The guy didn't want to pack it up for his move. It included the header all the way to the muffler, all...
Forum: Cosmetic Modification (Interior/Exterior/Lighting) 06-05-2018, 05:43 PM
Replies: 31
Views: 10,627
Posted By Clipdat
https://vignette.wikia.nocookie.net/glee/images/f/...

https://vignette.wikia.nocookie.net/glee/images/f/fc/Sue_is_in_a_rage.gif/revision/latest?cb=20111127210329
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 04-30-2018, 03:11 PM
Replies: 10
Views: 2,627
Posted By jamal
A diffuser by itself, on a stock, non-flat...

A diffuser by itself, on a stock, non-flat bottomed car, is probably not going to generate a whole lot of downforce, but on the other hand it won't be nothing. What the diffuser is actually doing is...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 04-30-2018, 01:58 PM
Replies: 10
Views: 2,627
Posted By NoHaveMSG
Most of the air that goes into the engine bay...

Most of the air that goes into the engine bay vents under the car.
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 04-30-2018, 08:58 AM
Replies: 10
Views: 2,627
Posted By churchx
Check velox hood vents thread. IIRC there was...

Check velox hood vents thread. IIRC there was some data both on temps & lift reduction.
Forum: Issues | Warranty | Recalls / TSB 03-15-2018, 01:48 PM
Replies: 9
Views: 7,363
Posted By Tcoat
I would not even guess at how long is too long...

I would not even guess at how long is too long but I waited and it blew and took out my whole clutch and flywheel. The clip is exactly how mine started out. It slowly got worse and then stopped...
Forum: Scion FR-S / Toyota 86 GT86 General Forum 01-12-2018, 12:31 PM
Replies: 109
Views: 24,489
Posted By humfrz
That's looks to be a good machine ....... but,...

That's looks to be a good machine ....... but, I'm still not seeing anything that would tempt me to trade in my 2013 ...;)


humfrz
Forum: Issues | Warranty | Recalls / TSB 12-11-2017, 10:19 PM
Replies: 9
Views: 2,833
Posted By gravitylover
I'd use a good two part epoxy like Hardman, fill...

I'd use a good two part epoxy like Hardman, fill the hole entirely and let it cure for the suggested amount of time. At this point you can drill and tap it and it should be good to go. It won't be...
Forum: Issues | Warranty | Recalls / TSB 12-11-2017, 01:30 PM
Replies: 9
Views: 2,833
Posted By Ultramaroon
It's a matter of getting the epoxy down into the...

It's a matter of getting the epoxy down into the area where the head of the fastener is molded into the fixture. Using the smallest spherical tip available, I would grind a single little slot...
Forum: Issues | Warranty | Recalls / TSB 11-24-2017, 02:38 PM
Replies: 9
Views: 2,833
Posted By humfrz
:slap: ........ a torque wrench cannot replace a...

:slap: ........ a torque wrench cannot replace a sense of ..... "tight nuff".

Bubba says to take it off, apply a heavy coat of bees wax to the places where it is supposed to seal and slap it back...
Showing results 1 to 30 of 92
Page 1 of 4 1 234

 
Forum Jump

All times are GMT -4. The time now is 10:32 AM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.