follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results


Page 1 of 4 1 234
Showing results 1 to 30 of 102
Search took 0.31 seconds. Search: Posts Made By: Skorov
Forum: Forced Induction 06-08-2015, 01:17 PM
Replies: 1,935
Views: 696,783
Posted By JD86
2 Inch coming from the turbo, 2.5 inch leading to...

2 Inch coming from the turbo, 2.5 inch leading to the inlet. Stage 4 is 2.5 on both sides.
Forum: Software Tuning 05-21-2015, 06:16 AM
Replies: 652
Views: 251,859
Posted By Kodename47
STFT will always fluctuate, however what you're...

STFT will always fluctuate, however what you're looking to do is ensure that the fluctuations are similarly equal over/below 0%. Yours are. There's not much you can do to reduce fuel trims and that's...
Forum: Forced Induction 04-10-2015, 12:01 PM
Replies: 1,935
Views: 696,783
Posted By GremlinGSP
The block fitting that is supplied with the AVO...

The block fitting that is supplied with the AVO kit - Is this the PCV valve or simply a fitting?
The block fitting was just a fitting the PCV valve was seperate (My fitting didn't fit and i...
Forum: Software Tuning 04-08-2015, 02:24 AM
Replies: 198
Views: 81,179
Posted By Kodename47
Nope, that's what you should do. To make it more...

Nope, that's what you should do. To make it more accurate you could set a flat AFR in the fuel table, and if you're using vgi's tool remember to increase the row offset by 1 or 2.
Forum: Software Tuning 04-07-2015, 05:18 AM
Replies: 198
Views: 81,179
Posted By Kodename47
From that log you can easily see the delay caused...

From that log you can easily see the delay caused by the difference in position. Now you can log the wideband I personally wouldn't worry about the stock one. There will always be a variance between...
Forum: Software Tuning 03-27-2015, 07:33 PM
Replies: 198
Views: 81,179
Posted By steve99
Yes car will run without rear 02, ecutek can use...

Yes car will run without rear 02, ecutek can use that ecu input for flex sensor.

As for disabling LTFT, have no experience with that but I believe Kodename47 has done that with his SC kit
Forum: Software Tuning 03-27-2015, 08:36 AM
Replies: 198
Views: 81,179
Posted By Sportsguy83
For your last questions, don't quote me on this...

For your last questions, don't quote me on this and someone can correct me, but I believe the long term fuel trims will affect your open loop fueling, meaning even if you tune the car at one point to...
Forum: Software Tuning 02-02-2015, 12:50 AM
Replies: 652
Views: 251,859
Posted By steve99
yes stock front 02 sensor is not wideband so wont...

yes stock front 02 sensor is not wideband so wont accuratly measure rich afr and its scale finishes at 12.1 stock scale.

you could put a proper wideband in second o2 position.
Forum: Software Tuning 01-26-2015, 08:54 PM
Replies: 326
Views: 92,605
Posted By steve99
I would aggree eith Kodename47 that E00I...

I would aggree eith Kodename47 that E00I unlikely to be compatable with prevoius vehicles

I tried D00G on my manual 2013 and it threw 2 CEL çodes P0155 re dash communiçations and another re...
Forum: Forced Induction 12-02-2014, 06:10 PM
Replies: 1,935
Views: 696,783
Posted By AVOturboworld
That's not meant for that purpose, no. That was...

That's not meant for that purpose, no. That was probably a spacer for the heat shield.
Forum: Forced Induction 11-27-2014, 06:30 PM
Replies: 1,935
Views: 696,783
Posted By protpibe
I would take a look at the charge pipe mount...

I would take a look at the charge pipe mount first. Did you install it correctly?
Forum: Cosmetic Modification (Interior/Exterior/Lighting) 09-16-2014, 07:27 PM
Replies: 153
Views: 41,842
Posted By wheelhaus
Yes, aint no thang. I have two JL 8W3v3 and they...

Yes, aint no thang. I have two JL 8W3v3 and they don't hit quite hard enough to cavitate the cabin and crack the windshield, but the light shroud is solid, no noise whatsoever. I specifically...
Forum: Cosmetic Modification (Interior/Exterior/Lighting) 07-29-2014, 02:36 PM
Replies: 9
Views: 2,230
Posted By Manic
Blue did pretty well to beat the Elite Four, but...

Blue did pretty well to beat the Elite Four, but consistency wise... he hasn't had the best track record against Red. Lopsided losses in Pallet Town, Outside Viridian, and on the S.S. Anne to name a...
Forum: Cosmetic Modification (Interior/Exterior/Lighting) 07-19-2014, 04:48 PM
Replies: 58
Views: 16,437
Posted By WhiteFRS69
this guy made a custom one, ...

this guy made a custom one,

http://www.ft86club.com/forums/showthread.php?t=20992

i would make it bigger if i made one



side note, i googled "custom Third brake light FRS"
Forum: Forced Induction 05-19-2014, 08:07 PM
Replies: 1,935
Views: 696,783
Posted By protpibe
Yeah the hole on the front cross member doesn't...

Yeah the hole on the front cross member doesn't line up. Just get a strip of aluminum or steel and make a bracket. Literally took 10 minutes

Sent from my HTC One using Tapatalk
Forum: Software Tuning 05-13-2014, 01:48 PM
Replies: 35
Views: 9,629
Posted By Kodename47
Well I went out today and had a play WRT the...

Well I went out today and had a play WRT the injector ratio and reduced all the lower load areas to varying different ratios and went for a drive. I did not see any PI use at ratios below 19.5%-20.3%...
Forum: Software Tuning 05-05-2014, 09:30 PM
Replies: 35
Views: 9,629
Posted By Sportsguy83
Ecutek tuners get RaceRom by default, then they...

Ecutek tuners get RaceRom by default, then they can create a basemap with the features and it can be flashed on any car. End users need to get racerom in order to DIY tune with the features.
Forum: Software Tuning 05-04-2014, 09:47 PM
Replies: 35
Views: 9,629
Posted By Sportsguy83
jamesm

jamesm
Forum: Cosmetic Modification (Interior/Exterior/Lighting) 04-22-2014, 06:54 PM
Replies: 79
Views: 28,661
Posted By blackfireball5
In case anyone is interested. Here is a DIY I did...

In case anyone is interested. Here is a DIY I did to turn the OEM fog light bezels into vents. While we wait. Lol.

http://www.ft86club.com/forums/showthread.php?t=63231

Sent from my Nexus 5...
Forum: Forced Induction 03-20-2014, 10:44 AM
Replies: 1,935
Views: 696,783
Posted By Sportsguy83
Avo Stage 3 price: Stage 3 Billet Turbo Kit...

Avo Stage 3 price:

Stage 3 Billet Turbo Kit [6MT Manual]


$9,000.00

Stage 3 Kit Hardware:
The AVO Stage 3 Kit utilizes all of the hardware of the Base Stage 1 kit, and adds on or upgrades...
Forum: Cosmetic Modification (Interior/Exterior/Lighting) 03-17-2014, 09:22 PM
Replies: 103
Views: 50,502
Posted By fatherfork
Well I can't be left out... I mounted mine...

Well I can't be left out... I mounted mine yesterday before painting (I was excited). I have a few modifications to make but I love it. Still planning a DIY (next week most likely).
...
Forum: Cosmetic Modification (Interior/Exterior/Lighting) 03-17-2014, 10:30 AM
Replies: 5
Views: 1,465
Posted By sshole
E46 people used to "paint" their white needles...

E46 people used to "paint" their white needles red using a red Sharpie marker.
Forum: Cosmetic Modification (Interior/Exterior/Lighting) 03-17-2014, 12:53 AM
Replies: 5
Views: 1,465
Posted By Acree
I would try film instead of paint. Just my $0.02.

I would try film instead of paint. Just my $0.02.
Forum: Forced Induction 03-13-2014, 04:48 PM
Replies: 3,109
Views: 1,274,879
Posted By SkAsphalt
You're a terrible person for quoting all of that....

You're a terrible person for quoting all of that.

Tomei is a full exhaust, it replaced another full header back exhaust.
Forum: Forced Induction 03-01-2014, 10:34 PM
Replies: 1,935
Views: 696,783
Posted By Sportsguy83
See above.. REALLY nice i'd say.

See above.. REALLY nice i'd say.
Forum: Forced Induction 03-01-2014, 09:31 PM
Replies: 1,935
Views: 696,783
Posted By Sportsguy83
Well, my data and fact were checked personally,...

Well, my data and fact were checked personally, but you knew that already...

It was pretty noticeable and accentuated inside the cabin, outside, etc. and going back to my initial post, moreso than...
Forum: Forced Induction 03-01-2014, 07:38 AM
Replies: 1,935
Views: 696,783
Posted By Sportsguy83
I never ran it with the stock intake. I do...

I never ran it with the stock intake. I do believe there is not much to be gained and it was more for the turbo sounds purposes.
Forum: Forced Induction 02-28-2014, 09:39 PM
Replies: 1,935
Views: 696,783
Posted By Sportsguy83
me and gdrider77 it fits, but have to make a...

me and gdrider77 it fits, but have to make a small custom bracket because the way its designed, it will point a bit to the sky, and to make it level with the AVO inlet, need a custom bracket. Not a...
Forum: Software Tuning 02-19-2014, 10:48 PM
Replies: 16
Views: 4,762
Posted By jamesm
Yes sir, it's the rom you mentioned.

Yes sir, it's the rom you mentioned.
Forum: Software Tuning 02-19-2014, 10:37 PM
Replies: 16
Views: 4,762
Posted By jamesm
Brzedit completely disables the ecu read process...

Brzedit completely disables the ecu read process (by changing the seed-key algorithm I believe). This means that you must first flash the brzedit 'stock' rom before you can connect and flash with...
Showing results 1 to 30 of 102
Page 1 of 4 1 234

 
Forum Jump

All times are GMT -4. The time now is 12:39 AM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.