Getting Shredical with the FR-S

[DarkPira7e]

Originally Posted by sachu

Thanks,

I used these spacers and just get the appropriate Hex nut to secure it.

https://www.mcmaster.com/90009A223/

You'll need to cut holes for them to line up to the block. Might also need to trim the plate in a few places with a dremel.

Thank you, I was afraid of that. I could've just cut and shaped a piece myself if I'd known I was paying $100 for paint and a jigsaw puzzle.

[sachu]

Originally Posted by DarkPira7e

Thank you, I was afraid of that. I could've just cut and shaped a piece myself if I'd known I was paying $100 for paint and a jigsaw puzzle.

Agreed. I'd DIY this if i were to do it again. Make sure to loctite those hex screws. I've had them fall out once.

[DarkPira7e]

Originally Posted by sachu

Agreed. I'd DIY this if i were to do it again. Make sure to loctite those hex screws. I've had them fall out once.

I can only imagine the excitement if a rattling noise coming from the front of the car as it rolls around in the splash pan. Thanks for the heads up.