HKS version 2 R&D supercharger - Page 14 - Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community

TIE Pilot · 02-17-2015, 07:43 AM

Its showing for sale in US site. $3800
http://www.hksusa.com/gt-supercharge...-for-fr-s-brz/

Sent from my iPhone using Tapatalk

Lee · 05-05-2015, 07:58 PM

Not long now

I mounted th traction cooler behind the IC to allow an oil cooler to be installed next door to it.

fluffy-reindeer-slayer · 05-23-2015, 01:52 AM

How did your install go im looking into this kit as well.

Lee · 05-23-2015, 11:08 AM

Install went fine and without issue, the instructions are a bit annoying at times if you try to follow the pictures, but follow the words and it should be ok. No issues with the car since install.

fluffy-reindeer-slayer · 05-24-2015, 12:47 AM

Are the installation instructions available in english or only japaneese

Lee · 05-24-2015, 08:25 AM

They come in english too, some words are funny though but its easy enough.

DarwinTuning · 05-28-2015, 03:28 PM

hks supercharger with no restrictor plate, fuel injectors+pump, no cats. 93 pump gas. It was 91F outside.
Car built and tuned in Moscow, Russia.

Calum · 05-28-2015, 05:40 PM

Quote:

Originally Posted by DarwinTuning

hks supercharger with no restrictor plate, fuel injectors+pump, no cats. 93 pump gas. It was 91F outside.
Car built and tuned in Moscow, Russia.

Thank you very much for posting, do you have a baseline for this car, or even a dyno that shows what a typical FRS/BRZ does on you dyno?

DarwinTuning · 05-28-2015, 10:09 PM

Quote:

Originally Posted by Calum

Thank you very much for posting, do you have a baseline for this car, or even a dyno that shows what a typical FRS/BRZ does on you dyno?

It's a standard dynojet, they all are +- the same. Although we use NM, not ft-lbs for torque. But WHP are the same.

I have old baseline on our mustang dyno, but since we sold it I will need to dig them up. I also have a dyno graph from mustang with hks sc installed, but car was on stock fuel system and no other mods. I believe this is the most powerful SC GT86 in Russia, it really opens up on top, I believe cams would do even more magic. We also may try different pulley on it in the future.
Car is currently tuned on brzedit, I may have to do ecutek in the near future. MAF sensor is already maxed out. Max boost was 0.9bar with 91f outside.

I must mention that this car has engine with lower CR. Also there is some headroom left in the tune on purpose, it's not the best dyno run.

Scott@HKSUSA · 05-29-2015, 02:46 PM

Quote:

Originally Posted by DarwinTuning

hks supercharger with no restrictor plate, fuel injectors+pump, no cats. 93 pump gas. It was 91F outside.
Car built and tuned in Moscow, Russia.

Nice numbers! Will you be racing the car at all (auto-x, circuit, drag)?

DarwinTuning · 05-29-2015, 11:46 PM

Quote:

Originally Posted by Scott@HKSUSA

Nice numbers! Will you be racing the car at all (auto-x, circuit, drag)?

Hi Scott,
Yes the car will see a lot of abuse on circuit.

I also dropped you a pm

DarwinTuning · 07-22-2015, 10:08 PM

Well, cant keep things under the rug forever.
We have two failed HKS supercarger units on hand. Same problem in both of them - thread is gone and unit is not spinning/blowing any more.
Also because customers didnt purchase through "authorized distributor" with 100% markup (this is happening in Russia) - there is no simple warranty available, just offer to send the unit to Japan. No need to say customers are not happy.
One of the owners is a member here.
Link to original post http://www.ft86club.com/forums/showp...7&postcount=79

Also pictures attached

nelsmar · 07-22-2015, 10:43 PM

damn thats rough on the warranty bit. =(

Efferalgan · 07-28-2015, 03:21 PM

Quote:

Originally Posted by nelsmar

damn thats rough on the warranty bit. =(

Indeed. Moreover, the replacement blower which I'm buying for my own money will be available (hopefully) only in mid-September. So my car will be out-of-action for at least 3 summer months, which is sort of sucks

02-17-2015, 07:43 AM	#183
TIE Pilot Senior Member Join Date: Sep 2012 Drives: TIE interceptor; BRZ13 Location: Miami Posts: 309 Thanks: 131 Thanked 132 Times in 88 Posts Mentioned: 18 Post(s) Tagged: 3 Thread(s)	HKS version 2 R&D supercharger Its showing for sale in US site. $3800 http://www.hksusa.com/gt-supercharge...-for-fr-s-brz/ Sent from my iPhone using Tapatalk __________________ "Speed has never killed anyone. Suddenly becoming stationary, that's what gets you." Jeremy Clarkson

05-28-2015, 03:28 PM	#189
DarwinTuning Junior Member Join Date: May 2015 Drives: GTR Location: Moscow Posts: 6 Thanks: 0 Thanked 8 Times in 5 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	hks supercharger with no restrictor plate, fuel injectors+pump, no cats. 93 pump gas. It was 91F outside. Car built and tuned in Moscow, Russia. Attached Images

07-22-2015, 10:08 PM	#194
DarwinTuning Junior Member Join Date: May 2015 Drives: GTR Location: Moscow Posts: 6 Thanks: 0 Thanked 8 Times in 5 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	Well, cant keep things under the rug forever. We have two failed HKS supercarger units on hand. Same problem in both of them - thread is gone and unit is not spinning/blowing any more. Also because customers didnt purchase through "authorized distributor" with 100% markup (this is happening in Russia) - there is no simple warranty available, just offer to send the unit to Japan. No need to say customers are not happy. One of the owners is a member here. Link to original post http://www.ft86club.com/forums/showp...7&postcount=79 Also pictures attached Attached Images

07-22-2015, 10:43 PM	#195
nelsmar Senior Member Join Date: Feb 2013 Drives: FR-S Location: Phoenix Posts: 2,605 Thanks: 733 Thanked 2,361 Times in 1,031 Posts Mentioned: 345 Post(s) Tagged: 3 Thread(s)	damn thats rough on the warranty bit. =( __________________ When I grow up, I wanna be God. My flickr - *Canibeat* Local magazine scout Old Setup: Vortech Supercharged 360WHP/262WTQ @ 11.5psi My build thread - WTF happened to nelsmar's car thread

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
North America to get Subaru version but not Toyota version?	Ground N Pound	BRZ First-Gen (2012+) -- General Topics	42	05-29-2014 12:23 AM
Hot Version Vol.116 ft. 86 & BRZ	larryw	BRZ Photos, Videos, Wallpapers, Gallery Forum	3	08-05-2013 02:14 AM
Hot Version Vol. 122	quik1987	FR-S & 86 Photos, Videos, Wallpapers, Gallery Forum	5	06-12-2013 10:03 AM
New hot version	4agze	Other Vehicles & General Automotive Discussions	19	03-07-2012 09:08 PM
Do you think we are going to see a trd version or 5axis version of the FRS next week	DIG1992	Scion FR-S / Toyota 86 GT86 General Forum	9	01-04-2012 06:59 AM

05-05-2015, 07:58 PM	#184
Lee Member Join Date: Sep 2014 Drives: GT86 Location: Scotland Posts: 67 Thanks: 11 Thanked 53 Times in 30 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	Not long now I mounted th traction cooler behind the IC to allow an oil cooler to be installed next door to it.

05-23-2015, 01:52 AM	#185
fluffy-reindeer-slayer Senior Member Join Date: Jun 2012 Drives: fr-s and tc2 Location: san antonio texas Posts: 166 Thanks: 18 Thanked 28 Times in 20 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	How did your install go im looking into this kit as well.

05-23-2015, 11:08 AM	#186
Lee Member Join Date: Sep 2014 Drives: GT86 Location: Scotland Posts: 67 Thanks: 11 Thanked 53 Times in 30 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	Install went fine and without issue, the instructions are a bit annoying at times if you try to follow the pictures, but follow the words and it should be ok. No issues with the car since install.

05-24-2015, 12:47 AM	#187
fluffy-reindeer-slayer Senior Member Join Date: Jun 2012 Drives: fr-s and tc2 Location: san antonio texas Posts: 166 Thanks: 18 Thanked 28 Times in 20 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	Are the installation instructions available in english or only japaneese

05-24-2015, 08:25 AM	#188
Lee Member Join Date: Sep 2014 Drives: GT86 Location: Scotland Posts: 67 Thanks: 11 Thanked 53 Times in 30 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	They come in english too, some words are funny though but its easy enough.

User Name		Remember Me?
Password