Originally Posted by Payload (Post 3293466)

Has anyone yet began to unlock the stock potential of there gt86 vehicles ecu with an "Openflash Tablet" provided by RomRaider written software updates, or Ecu-Tek hardware..??? Please note that this doesn't apply to owners of force induction FA20 engines, explicitly meaning without the use of a turbo-charger or super-charger bolt-on to the FA20 engine block...

Originally Posted by Payload (Post 3293536)

Cool, so have you approximated and determined your performance results. If you don't mind me asking what are your guesstimated power and torque out-put ratings from the fly wheel..😀

I have an idea of where my performance ratings stand ;even though I haven't dyno tested the car.. I'll share my values and tell you how I arrived at my guesstimated numbers..

Originally Posted by Payload (Post 3293553)

This FA20 engine is capable of over 300 hp on just tuning the software via "openflash"or "ecu tek" without any force induction bolt-ons, I did some research with other forums discussed about this matter and just to make sure what I read was accurate I did some checks and checked out some numbers with an online fuel injector calculator, after using it myself I can provide some valid testimony to this subject matter myself.. The only the problem with a tune for this car minus any bolt- on force induction system is the torque rating.. Your not going to pick up extraordinary torque rates in the low rpm tech region say btwn 2,000-3,000rpm gauge until you get to about (X~>4,800)rpm or past it, the force induction has an advantage at high torque out-puts in the very low rpm region, that maybe the sole purpose of even using force induction. It's a waste of time of doing force induction just to say that your car can do 300+ hp because a stand alone tune will give the same power output in the higher rpm region of the techcometer..That's probably why Toyota reps took so long to even consider a turbo.. The power gains are solely in the users tunning capabilities for 300+ without using any force induction bolt-ons to the engine... Based on what I've noticed, force induction for a stock FA20 engine would only make sense if your trying to put on extra 200hp to the fly wheel or drag racing purposes.. Enjoy my friends����

Originally Posted by Payload (Post 3293569)

What is that image in your reply box ??

Originally Posted by DarkPira7e (Post 3293591)

I can't believe so many of us wasted our time with stupid turbos and Superchargers. The answer was within our reach this whole time- methamphetamine!