Help with poke on rear

[ZionsWrath]

If you look at page 2 of this thread there are some pics of stock height BRZ with 9.5 +45 rear.

http://www.ft86club.com/forums/showthread.php?t=21697

Page 1 and a few other pics throughout the thread show with a drop it is flush in the rear. I think you are still gonna poke with the specs you said unless you run a lot of camber and/or a significant drop.

[juanam0909]

[IMG][/IMG]

18x9.75 20 offset

[Ash.B]

juanam0909 thank you so much for that, any pictures from the rear of the car to see the camber/poke?

[ZionsWrath]

18x9 + 25 lowered on sportlines. i don't like it :\

http://www.ft86club.com/forums/showthread.php?t=37848

[Ash.B]

The front is too much for me but the rear is actually not too bad in terms of me thinking it would stick out much more than that ^_^ thank you ZionsWrath

[juanam0909]

Originally Posted by Ash.B

juanam0909 thank you so much for that, any pictures from the rear of the car to see the camber/poke?

ash ill put pictures this weekend when i wash my car lol. but what set up are you trying to do? you want staggered or square ?

[WolfsFang]

Originally Posted by Ash.B

LOl damit I really should have been paying attention but I think its safe to say 2am thread titles are never a good idea. I am sorry I dont have proper ET offsets just yet its just what the wheel guy I am buying the wheels off told me. He asked me to measure the distance from tyre to spring to gauge clearance and then took the factory specs and gave me a 1.4cm poke of the wheel in the rear guard.

WolfsFang any more pictures of your set up? I have looked through your thread, is that image above with 2" of poke from the rear guards?

I can take more pics tomorrow when I lower it again after my oil change.

Sent from my XT1060 using Tapatalk

[Ash.B]

Thank you both very much ^_^ I am going for staggered set up Juanam0909 so hopefully the specs I post above will sit decently on my car.

[juanam0909]

Yea you shouldn't have any problem rubbing at all I'm about 1.5 dropped and no problems

Sent from my LGMS769 using Tapatalk

[juanam0909]

Just make sure when you get wheels be sure what lug nut sizes you need and hub centric ring are recommended.

Sent from my LGMS769 using Tapatalk

[Ash.B]

Juanam0909 for sure I will take care of that, I will be ordering some Work lug nuts and I will get hub centric rings as well, I was more worried about the poke from the guard since I am not getting that much poke to be hellaflush with the trend its just what the offset became for me to get 3" of dish on the rear. I look forward to some pictures so I know what I am getting myself into

[dori.]

Originally Posted by Ash.B

Sorry I asked him again and I got them ^_^

17x8 with 2.5" dish ET 22
17x9 with 3" dish ET 24

dunno what suspension you're gonna run, but you will need to be dropped on coilovers to be flush. your fitments are on the aggressive side for this car.

if your car is at stock height or on springs with a small drop (1 inch or less), I would recommend against running them.

[Ash.B]

going HKS Hipermax 5's looking at a 1" drop would do more pending drive way clearance thats my main concern

[dori.]

just get coils and reverse into your driveway LOL