Do I need rear toe arms?

[Phothiraj]

I have a 2" clearance from the ground to my rocker panel just went out and measured

[humfrz]

Originally Posted by Phothiraj

i mean i've been dailying for the past 4 years this low. Now that I've finally paid my car off, I have a few extra bucks to start buying car parts

Welp, you must live in a different part of CT than I did ……




humfrz

[GoZ21]

Originally Posted by Phothiraj

I have a 2" clearance from the ground to my rocker panel just went out and measured

Did you resolve all of this? guys on the forums here dont like anything having to do with stance or cars lowered more than what they need for the track. But yes you will need toe arms with the PBM lca's there is no question about it.

[Lakitu]

I have new wheels, tires, and coilovers on factory alignment. I'm lowered with a 1" gap between fender and wheels all around, 5" from side skirt to ground. So if I'm not looking to go any lower, so with this setup I don't actually need aftermarket toe arms and control arms to have an alignment done properly, right?

[ZDan]

Originally Posted by Lakitu

I have new wheels, tires, and coilovers on factory alignment. I'm lowered with a 1" gap between fender and wheels all around, 5" from side skirt to ground. So if I'm not looking to go any lower, so with this setup I don't actually need aftermarket toe arms and control arms to have an alignment done properly, right?

Shouldn't need aftermarket toe arms or control arms. I'm at the same height (1.25" lowered all around), aligned at -2.5° rear camber, zero rear toe