WTB: BRZ or 10 series/monogram 8 pin connector + length of wiring harness

[NahumCC]

I'm only interested in trying to be salvage from a BRZ (if they use the same 8 pin connector) or 10 series/monogram/release series that takes a hit in the front end where the car is totaled and the lights themselves are not salvageable.


What I want are both sides 8 pin connectors to the headlights (male and female) + as much of the wiring harness on each side from the car going to the headlights that is feasible. Just cut straight through on the headlight side after the connector going into the ballast and as far back into the main wiring harness.


Connectors must be in good shape and salvageable. Hoping to make a plug and play connector for my Bi-Xenon fog light project as cost effective as possible.

[that_one_guy]

I've been looking for 8 pin connectors myself to swap BRZ headlights into my FRS but haven't found anything yet. There are several people who have done this swap but I can't figure out where they got their connectors.

[NahumCC]

I ordered some through alibaba and am waiting for them to come in and test fit them.

Sent from my SAMSUNG-SM-G870A using Tapatalk

[that_one_guy]

Originally Posted by NahumCC

I ordered some through alibaba and am waiting for them to come in and test fit them.

Sent from my SAMSUNG-SM-G870A using Tapatalk

I checked there but couldn't find anything that looked it would fit. Do you have the link? Thanks!

[NahumCC]

Originally Posted by that_one_guy

I checked there but couldn't find anything that looked it would fit. Do you have the link? Thanks!

It's in my other thread about the bi-xenon fogs I'm doing. That project is on hold until I get the lot of 5 I bought. From the photos they looked to be a match. It was cheap enough that it wasn't a big deal if they end up being tossed out.