The Gen 2 Exhaust Thread - Page 27 - Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community

Robertw · 03-16-2022, 08:07 AM

Has anyone tried the Greddy Supreme SP axle back on the 2022 cars?

Falken86 · 03-16-2022, 08:18 AM

Quote:

Originally Posted by Robertw

Has anyone tried the Greddy Supreme SP axle back on the 2022 cars?

I have the Greddy supreme sp catback from my first gen I will be putting on
once my car comes in.

LRNAD90 · 03-16-2022, 08:23 AM

Quote:

Originally Posted by Robertw

Has anyone tried the Greddy Supreme SP axle back on the 2022 cars?

https://www.ft86club.com/forums/show...&postcount=301

https://www.ft86club.com/forums/show...&postcount=304

mr.whiskers · 03-16-2022, 10:01 AM

Quote:

Originally Posted by danson

Here's my Borla S-type install. No issues with fitment or tip alignment at all. Looks perfect and the tips sit much further out than the stock tips (which look almost TOO recessed to me)

Great sound when accelerating and downshifting. Zero drone at highway or low RPM cruising.

Sounds very quiet to be honest

danson · 03-16-2022, 11:09 AM

Quote:

Originally Posted by mr.whiskers

Sounds very quiet to be honest

Did you use headphones? At first I listened to this clip on my phone and was surprised at how quiet it sounded. I listened to it later with an over the ear headset and the deep sound came through much better.

I'm sure it's not as loud as alot of the setups, but it's definitely not what I consider quiet.

mr.whiskers · 03-16-2022, 11:11 AM

Yes I did use the headphones

sds · 03-16-2022, 11:36 AM

Quote:

Originally Posted by danson

Here's my Borla S-type install. No issues with fitment or tip alignment at all. Looks perfect and the tips sit much further out than the stock tips (which look almost TOO recessed to me)

Great sound when accelerating and downshifting. Zero drone at highway or low RPM cruising.

Do you remember how close the center muffler was to your driveshaft? It's quite close for me...

scuzzy · 03-16-2022, 12:45 PM

Quote:

Originally Posted by Daedex

If anyone has the HKS Hi-Power SPEC-L2 exhaust system, post some sound clips! We need more of em!

just found this . . .

Robertw · 03-16-2022, 01:22 PM

Quote:

Originally Posted by LRNAD90

https://www.ft86club.com/forums/show...&postcount=301

https://www.ft86club.com/forums/show...&postcount=304

Thanks. First link shows a video clip of the axle back on a 1st gen, the second link is a link to a dead FB video.

danson · 03-16-2022, 01:26 PM

Quote:

Originally Posted by sds

Do you remember how close the center muffler was to your driveshaft? It's quite close for me...

Funny you mention this, I accidentally sheared the bolt that mated the exhaust up to my stock front pipe. I went to Subaru and got a replacement bolt but they would not put it on so I drove over to a Mieneke car care and they threw it on for me( no charge!). When it was up on their lift he showed me that the muffler was rubbing the drive shaft just a little bit so he was able to loosen the connections and twist it slightly to give it more clearance but yes it is very close.

danson · 03-16-2022, 01:28 PM

Quote:

Originally Posted by Robertw

Thanks. First link shows a video clip of the axle back on a 1st gen, the second link is a link to a dead FB video.

Axlebacks from 1st Gen don't fit, only newly designed specifically for 22 work. I'm unfamiliar with the greddy lineup so they may have some 22 stuff out to already

sds · 03-16-2022, 01:31 PM

Quote:

Originally Posted by danson

Funny you mention this, I accidentally sheared the bolt that mated the exhaust up to my stock front pipe. I went to Subaru and got a replacement bolt but they would not put it on so I drove over to a Mieneke car care and they threw it on for me( no charge!). When it was up on their lift he showed me that the muffler was rubbing the drive shaft just a little bit so he was able to loosen the connections and twist it slightly to give it more clearance but yes it is very close.

Keep an eye on it. I had to do the same (fiddle with everything) to buy myself a few additional mm of clearance.

But if you end up wheel hopping, accelerating hard, or anything that would cause the differential (and driveshaft) to shift, you might contact again.

euroshowoff · 03-17-2022, 02:57 PM

i hope the hks legamax will come out with a non-burnt tip option...i'm thinking the size of the tips are perfect compared to the greddy....if only the jdm sti exhaust was a little bit cheaper

hks legamax 124mm tips
oem jdm STI exhaust 120mm tips
greddy supreme 114mm tips

Grif · 03-17-2022, 05:11 PM

I am also seriously considering the Sard axle-back from Japan.
Lighter by 3kg, real titanium tips and not too loud.

https://www.sard.co.jp/parts/products/exhaust/suzt2/

The video has fairly ordinary sound quality, however the note in the upper range of the rpm is nice and clean.

03-17-2022, 02:57 PM	#377
euroshowoff Senior Member Join Date: Apr 2013 Drives: 2015 Tacoma Location: VA Posts: 157 Thanks: 19 Thanked 32 Times in 27 Posts Mentioned: 2 Post(s) Tagged: 0 Thread(s)	i hope the hks legamax will come out with a non-burnt tip option...i'm thinking the size of the tips are perfect compared to the greddy....if only the jdm sti exhaust was a little bit cheaper hks legamax 124mm tips oem jdm STI exhaust 120mm tips greddy supreme 114mm tips __________________ "Bah Weep Granah Weep Nini Bong" Old: 2013 Arengto FR-S Current: 2015 Tacoma/2020 Sequoia Pro Future: 2022 CWP Limited Est Delivery 06/22

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
FR-S and BRZ Exhaust Compilation Thread	Spd229	Engine, Exhaust, Transmission	660	01-03-2024 10:10 AM
2022+ Exhaust compilation thread	Yoshoobaroo	Engine, Exhaust, Transmission	22	04-22-2022 06:17 AM
The Boosted Exhaust Thread	The Racers Line	Forced Induction	49	06-05-2014 01:13 AM
The Exhaust Weights thread	qoncept	Engine, Exhaust, Transmission	5	06-12-2013 02:34 PM
Agency Power Exhaust Thread PT II	vividracing	Engine, Exhaust, Transmission	222	07-28-2012 12:52 AM

03-16-2022, 08:07 AM	#365
Robertw Senior Member Join Date: Nov 2021 Drives: 1996 Turbo Miata Location: MA Posts: 150 Thanks: 54 Thanked 92 Times in 48 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	Has anyone tried the Greddy Supreme SP axle back on the 2022 cars?

03-16-2022, 11:11 AM	#370
mr.whiskers Senior Member Join Date: Feb 2022 Drives: '22 BRZ Location: Canada Posts: 159 Thanks: 24 Thanked 46 Times in 32 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	Yes I did use the headphones

03-17-2022, 05:11 PM	#378
Grif Member Join Date: Jul 2021 Drives: BRZ 2nd gen Location: Sydney Posts: 50 Thanks: 24 Thanked 40 Times in 23 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	I am also seriously considering the Sard axle-back from Japan. Lighter by 3kg, real titanium tips and not too loud. https://www.sard.co.jp/parts/products/exhaust/suzt2/ The video has fairly ordinary sound quality, however the note in the upper range of the rpm is nice and clean.

User Name		Remember Me?
Password